Yuan Zhang

Mr. Yuan Zhang

School of Earth and Environment, Anhui University of Science and Technology, Huainan, 232001, China

Research Focus & Metrics

Academic Career Length

16Years (2011-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 December 2020 in Geofluids
Verified
Journal Article
Open access
PDF file
Yuan ZhangYuan Zhang
Yuan Zhang
NSNan Shan
Nan Shan
YZYou-Kuan Zhang
You-Kuan Zhang
XLXiuyu Liang
Xiuyu Liang
Hydraulic conductivity is an important parameter for predicting groundwater inrush in coal mining worksites. Hydraulic conductivity varies with deformation and failure of rocks induced by mining. Understanding the evolution pattern of hydraulic conductivity during mining is important for accurately predicting groundwater inrush. In this study, variations of hydraulic conductivity of rock samples during rock deformation and failure were measured using the triaxial servo rock mechanic test in a laboratory. The exponential formula of hydraulic conductivity-volume strain was proposed based on the experimental data. The finite-difference numerical model FLAC3D was modified by replacing constant hydraulic conductivity with the strain-dependent hydraulic conductivity. The coupled water flow and rock deformation and failure were simulated using the modified model. The results indicate that in the early time, the rocks undergo elastic compression with increasing rock strain, resulting in a decrease in hydraulic conductivity; then, the microcracks and fissures appear in the rock after it yields results in a sudden jump in hydraulic conductivity; in the later time, the hydraulic conductivity decreases gradually again owing to the microcracks and fissures that were compacted. The conductivity exponentially decreases with the volumetric strain during the periods of both elastic compression and postyielding. The simulated stress-strain curves using the modified model agree with the triaxial tests. The modified model was applied to the groundwater inrush of a coal mining worksite in China. The simulated water inflow agrees well with the observed data. The original model significantly underestimates the water inflow owing to it to neglect the variations of the hydraulic conductivity induced by mining.

31 January 2011 in Mining Science and Technology (China)
Verified
Journal Article
Closed access
Yuan ZhangYuan Zhang
Yuan Zhang
YBYuan Baoyuan
Yuan Baoyuan
WLWang Lin
Wang Lin

24 January 2022 in Water
Verified
Journal Article
Open access
PDF file
Yuan ZhangYuan Zhang
Yuan Zhang
Yuan ZhangYuan Zhang
Yuan Zhang
XMXiangshuai Meng
Xiangshuai Meng
Soft soil generally has a high water content, and the accurate quantification of its mechanical parameters is an important aspect of foundation design and disaster prevention. The mechanical parameters of soft soil have significant spatial variability or heterogeneity due to the complex deposition process of soil, leading to the high uncertainty of the quantifications of its parameters. Therefore, understanding the spatial variability of the parameters is an important approach to reduce uncertainty. In this study, the high-resolution (0.1 m) tip resistance (qc) and side friction (fs) of 18 soft soils in coastal areas were measured using the Dual-bridge CPT in-situ test. The vertical and horizontal variabilities of qc and fs were investigated using the random field theory. The results showed that both qc and fs are stationary and ergodic. The coefficient of variation of vertical fs is much higher than that of qc. On the one hand, fs may be vulnerable to noise, and its test accuracy is lower than qc; on the other hand, it may be that the spatial variability of the residual strength of soft soil may be greater than that of its failure strength. The horizontal correlation distance and coefficient of variation of qc and fs have no obvious change trend along the depth direction, but compared with the coefficient of variation curve, it was found that the change trends of qc and fs are basically the same, which is considered to be related to the properties of the soil layer. The research results can provide support for the spatial variability evaluation and reliability analysis of soft-soil engineering in this area. At the same time, it can also provide a theoretical basis for the layout of exploration engineering and sampling spacing.

27 March 2024 in Water
Verified
Journal Article
Open access
PDF file
GXGuanhong Xiao
Guanhong Xiao
Yuan ZhangYuan Zhang
Yuan Zhang
The hydrogeological conditions of Huainan Coalfield are complex. The Taiyuan formation limestone water (Taihui water) in this area is a direct threat to the water source of the 1# coal mining floor. In order to prevent and control water disasters, Gubei Coal Mine adopted ground high-pressure grouting with fly ash cement to block the hydraulic connection between the Taiyuan formation limestone aquifer and the Ordovician limestone aquifer. However, the injected slurry will destroy the original hydrochemical balance of Taihui water and change its hydrochemical characteristics. Taking the influence area of the 2# karst collapse column in the Beiyi 1# coal mining area of Gubei Coal Mine as an example, a total of 25 Taihui water samples were collected. The hydrochemical characteristics and evolution law of Taihui water before and after grouting are studied via the multivariate statistical method. The research methods include constant index statistics, Piper diagram, correlation analysis, ion combination ratio, and saturation index analysis. The results show that after grouting, the concentrations of Na+ + K+, Ca2+, Mg2+, and Cl− in Taihui water decrease, while the concentrations of SO42− and HCO3− increase. The average values of PH and TDS become larger. The hydrochemical types of Taihui water are more concentrated, mainly HCO3-Na and Cl-Na. The correlations between conventional indicators decrease. According to the analysis of ion combination ratio, dissolution, cation exchange, and pyrite oxidation mainly occur in Taihui water, and these effects are enhanced after grouting. The saturation index results show that after grouting, the saturation index of dolomite, calcite, and gypsum is significantly reduced, and the saturation index of rock salt is slightly increased. The conclusion of this study is that the hydrochemical characteristics of Taihui water are greatly affected by fly ash cement. Moreover, because fly ash cement contains a lower calcium oxide content than ordinary Portland cement, the effect of fly ash cement on the ion concentration of Taihui water and the resulting hydrogeochemical effect are significantly different. Therefore, in the treatment of mine water disasters, the hydrogeochemical evolution law affected by fly ash cement grouting should be identified.

1 May 2021 in Water
Verified
Journal Article
Open access
PDF file
Yuan ZhangYuan Zhang
Yuan Zhang
Yuan ZhangYuan Zhang
Yuan Zhang
GZGuifang Zhang
Guifang Zhang
MZManman Zhang
Manman Zhang
On the basis of the one-dimensional heat conduction–convection equation, a thermal effect model for vertical groundwater migration in the stratified rock mass was established, the equations for temperature distribution in layered strata were deduced, and the impacts of the vertical seepage velocity of groundwater and the thermal conductivity of surrounding rocks on the temperature field distribution in layered strata were analyzed. The proposed model was employed to identify the thermal convection and conduction regions at two temperature-measuring boreholes in coal mines, and the vertical migration velocity of groundwater was obtained through reverse calculation. The results show that the vertical temperature distribution of the layered rock mass is subject to the migration of the geothermal water; the temperature curve of the layered formation is convex when the geothermal water travels upward, but concave when the water moves downward. The temperature distribution in the stratified rock mass is also subject to the thermal conductivity of the rock mass; greater thermal conductivity of the rock mass leads to a larger temperature difference among regions of the rock mass, while weaker thermal conductivity results in a smaller temperature difference. A greater velocity of the vertical migration of geothermal water within the surrounding rock leads to a larger curvature of the temperature curve. The model was applied to a study case, which showed that the model could appropriately describe the variation pattern of the ground temperature in the stratified rock mass, and a comparison between the modeling result and the measured ground temperature distribution revealed a high goodness of fit of the model with the actual situation.

1 January 2020 in Advances in Civil Engineering
Verified
Journal Article
Open access
PDF file
BSbinyang sun
binyang sun
PZPingsong Zhang
Pingsong Zhang
Yuan ZhangYuan Zhang
Yuan Zhang
The deformation mechanism of the protective coal and rock pillar area outside a stope is an important parameter for setting a reasonable size. In this paper, based on the geological condition of working face 1231(1) in a mine in Huainan, a method that combines the use of a borehole and Brillouin optical time domain reflectometry (BOTDR) was proposed to analyze the stress variation laws of coal and rock pillar areas, and the parameters of the monitoring borehole and installation technique of the sensing optical cables were designed. Based on the monitoring data, the strain distribution characteristics of the sensing optical cables and their relationship with the rock strata were analyzed, the development law of coal and rock strata deformation during the mining process was revealed, and the transverse influence range of the coal and rock pillar affected by mining was reasonably divided. According to the results, the sensing optical cables show an overall trend of tensile strain, with a maximum value of 1800 με, and the main areas of rock strata deformation occur near the interface of rock strata. The range of rock strata disturbance along the borehole direction was approximately 38 m, and the maximum deformation of rock strata after the disturbance, namely, the displacement, was 24.87 mm. A numerical model was constructed to acquire the strain variation characteristic within 100 m in the outer floor of the working face. The transverse range of the floor disturbance was analyzed to be 30–36 m. The field test had good correspondence with the numerical simulation results, which indicates that the optical fiber testing technology can effectively describe the stress variation in the coal and rock strata. The test results can provide technical support for the rational setting of coal and rock pillars and disaster prevention and control. The research direction of deep rock mass testing is discussed, and optical fiber testing in boreholes is considered an effective method for studying deep dynamic disaster control.