Waveguides made of poly-methyl-methacrylate (PMMA) play a major role in the homogeneous distribution of display backlights as a matrix for solid-state dye lasers and polymer optical fibers (POFs). PMMA is favored because of its transparency in the visible spectrum, low price, and well-controlled processability. Nevertheless, technical drawbacks, such as its limited temperature stability, call for new materials. In this work, the copolymerization technique is used to modify the properties of the corresponding homopolymers. The analytical investigation of fourteen copolymers made of methyl-methacrylate (MMA) or ethyl-methacrylate (EMA) as the basis monomer is summarized. Their polymerization behaviors are examined by NMR spectroscopy with subsequent copolymerization parameter evaluation according to Fineman-Ross and Kelen-Tüdös. Therefore, some r-parameter sets are shown to be capable of copolymerizations with very high conversions. The first applications as high-temperature resistant (HT) materials for HT-POFs are presented. Copolymers containing isobornyl-methacrylate (IBMA) as the comonomer are well-suited for this demanding application.
In the last years a lot of different pump configurations were investigated for thulium doped fiber amplifiers (TDFA) in the S-band. Since the TDFA is using a four-level transition with long lifetime of the lower amplifier level, it turned out, that pumping with two wavelengths was most effective. Comparing the results of fluoride fibers doped with 2000 ppm and 5000 ppm thulium, we show that an avalanche effect significantly improves the efficiency of TDFAs with the highly thulium doped fiber when pumped at 1050 nm only and at the same time makes the dual-pump configuration 790/1050 nm inefficient. For the measurements we used self-made fluoride fibers
We present a novel fast method to compute point-based Computer Generated Holograms with occlusion on the GPU, using modern hardware capabilities. Our method offers a promising new route towards real-time calculation of high-resolution holograms.
We present a calibration method that correlates in-line measurement results from a digital holographic microscope (DHM) integrated into a two-photon polymerisation system (TPP) with offline results from a high-resolution laser scanning microscope (LSM). Our findings indicate that a single calibration step for a specific polymer is sufficient to reliably monitor the fabrication of various structures. In future, this approach will make it possible to adapt the production process to the manufactured structure geometry in real time.
Optical frequency domain reflectometry (OFDR) is an interferometric method which allows to determine the spatial distribution of the gain along the active fiber in a fiber amplifier. As a non-destructive tool it is ideal to find the optimum fiber length especially of co-directional pumped fiber amplifiers. In this paper we explain the OFDR method and discuss measurement results from different S-band TDFA setups.