In this paper, the inception of tip vortex cavitation in weak water has been predicted using a numerical simulation, and a new scaling concept with variable exponent has also been suggested for cavitation inception index. The numerical simulations of the cavitating flows over an elliptic planform hydrofoil were performed by using the RANS approach with a Eulerian cavitation model. To ensure the accuracy of the present simulations, the effects of the turbulence model and grid resolution on the tip vortex flows were investigated. The turbulence models behaved differently in the boundary layer of the tip region where the tip vortex is developed, which resulted in different pressure and velocity fields in the vortex region. Furthermore, the Reynolds stress model for the finest grid showed a better agreement with the experimental data. The tip vortex cavitation inception numbers for the foil, predicted by using both wetted and cavitating flow simulation approaches, were compared with the measured cavitation index values, showing a good correlation. The current cavitation scaling study also suggested new empirical relations as a function of the Reynolds number substitutable for the two classic constant scaling exponents. This scaling concept showed how the scaling law changes with the Reynolds number and provided a proper scaling value for any given Reynolds numbers under turbulent flow conditions.

In this study, the numerical investigation of the flow around the SUBOFF submarine model is performed by using the Detached Eddy Simulation (DES) method which is developed based on the SST k-ω turbulence model. At the DES analysis level, complex vortical flows around the submarine model are caused mainly by the vortices due to the appendages and their interactions with the flows from the hull boundary layer and other appendages. The complexity and scale of the vortical flow obtained from the numerical simulations are highly dependent on the grid. The computed local flow properties of the submarine model are compared with the available experimental data showing a good agreement. The DES analysis more reasonably estimates the physical phenomena inherent in the experimental result in a low radius of the propeller plane where vortical flows smaller than the RANS scale are dominant.

Submarines with pumpjet propulsors have recently been used in many countries to improve their propulsion and noise performance. The pumpjet has the advantage of improving noise and cavitation performance by increasing the pressure inside the duct, and it has good efficiency at a low advance ratio. This study analyzed the propulsive performance of a pumpjet propulsor affixed to a SUBOFF submarine as a function of variations in the design parameters using computational fluid dynamics analysis. The incidence angle and camber of the duct and the pitch angle of the stator were selected as the design parameters. To investigate the propulsion performance as a function of the design parameter variations, each case’s thrust, torque, and efficiency were compared, and the velocity and pressure fields of each case were analyzed. In addition, the efficiency was analyzed using the non-dimensional mass flow rate and area ratio difference for each case. The duct incidence angle contributed most dominantly to the dimensionless flow rate and the difference in area ratio, and these two factors resulted in high efficiency at certain values. It is expected that further research will be conducted in the near future that takes into account cavitation inception speed and cavitation.

서 론 선박 및 잠수함의 프로펠러에서 발생하는 캐비테이션은 프로 펠러의 성능 저하의 원인이 되며 변동압력 증가로 인한 승선감 감소와 프로펠러 침식의