This publication deals with the navigation of unmanned aerial vehicles (UAVs) moving in the magnetic field of two long, straight, parallel conductors, which is of high interest for several new technical applications. How the position and orientation of the UAV can be calculated using a minimal number of only three three-axis magnetometers are discussed. It is shown that the angles can be determined without the knowledge of the conductor currents and the magnetic field equations, but only by combining the sensor measurements with the rotation matrix and exploiting a characteristic property of the magnetic field. Furthermore, different strategies were investigated to determine the respective sensor positions. An analytical solution was derived from the nonlinear magnetic field equations, which promises a low computational time. It is shown that for a given sensor, several solutions exist, from which the correct one has to be selected. Therefore, a specific detection method is introduced. Once the solution is known, the UAV location can be determined. Finally, the overall algorithm was tested by simulations far from and near the conductors with superimposed typical magnetic noise.
13 February 2023 in IEEE Transactions on Magnetics
This paper deals with predictive maintenance of infrastructure objects, focusing on the inspection of bridges. To achieve this goal, unmanned aerial vehicles place measuring units for data collection at different points of the bridge. This work deals with the question of how these measuring units can be found and removed by them later. For this purpose, a magnetic localization method based on the STAR method is presented. In contrast to the STAR method, which only detects the center of a magnetic target, a modified version called SRIOD is implemented here, where the orientation of the magnetic target can also be detected. This is essential information if the unmanned aerial vehicle is to grab the measuring unit with a robotic arm. In this regard, two identical permanent magnets are integrated into the measuring unit, whose gradient tensor contraction of the magnetic flux density distribution has a directed asymmetric surface when considering the contours of constant values. This creates a magnetic invisible reference plane that can be detected with a magnetic gradiometer. The method is verified both in simulation and experimentally in a laboratory setup.
This paper deals with predictive maintenance of infrastructure objects, focusing on the inspection of bridges. To achieve this goal, unmanned aerial vehicles place measuring units for data collection at different points of the bridge. This work deals with the question of how these measuring units can be found and removed by them later. For this purpose, a magnetic localization method based on the STAR method is presented. In contrast to the STAR method, which only detects the center of a magnetic target, a modified version called SRIOD is implemented here, where the orientation of the magnetic target can also be detected. This is essential information if the unmanned aerial vehicle is to grab the measuring unit with a robotic arm. In this regard, two identical permanent magnets are integrated into the measuring unit, whose gradient tensor contraction of the magnetic flux density distribution has a directed asymmetric surface when considering the contours of constant values. This creates a magnetic invisible reference plane that can be detected with a magnetic gradiometer. The method is verified both in simulation and experimentally in a laboratory setup.
In this paper we extend our previous work on UAV localization based on the magnetic field strength. The method is based on a magnetic flux density distribution in vicinity of two very long, thin and parallel transmission lines. An UAV is equipped with 4 magnetometers, positioned so that obtained measurements give unique solution to an optimization problem used to find relative position and orientation of the UAV with respect to conductors. Several sets of experiments, undertaken on a laboratory setup, confirmed validity of the method for both solutions - analytical and numerical optimization. Obtained results, compared with high precision motion capture system, are within range of standard RTK positioning.