Thomas Stoecker

Thomas Stoecker

orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

25 September 2014 in Journal of Sensors and Sensor Systems
Verified
Journal Article
Open access
PDF file
MBM. Bektas
M. Bektas
DHD. Hanft
D. Hanft
DSD. Schönauer-Kamin
D. Schönauer-Kamin
TSThomas Stoecker
Thomas Stoecker
GHG. Hagen
G. Hagen
Ralf MoosRalf Moos
Ralf Moos
The gas sensing properties of resistive gas sensors of BaFe0.7Ta0.3O3-δ (BFT30) prepared by the so-called aerosol deposition method, a method to manufacture dense ceramic films at room temperature, were investigated. The electrical response of the films was investigated first under various oxygen concentrations and in a wide temperature range between 350 and 900 °C. Between 700 and 900 °C, the conductivity of BaFe0.7Ta0.3O3-δ (BFT30) depends on the oxygen concentration with a slope of almost 1/4 in the double-logarithmic plot vs. oxygen partial pressure. In addition, the sensor response is temperature independent. BFT30 responds fast and reproducibly to changing oxygen partial pressures even at 350 °C. The cross-sensitivity has been investigated in environments with various gases (C3H8, NO, NO2, H2, CO, CO2, and H2O) in synthetic air between 350 and 800 °C. BFT30 exhibits good sensing properties to NO between 350 and 400 °C in the range from 1.5 to 2000 ppm with a high selectivity to the other investigated gas species. Thus this semiconducting ceramic material is a good candidate for a temperature-independent oxygen sensor at high temperatures with the application in exhausts and for a selective nitrogen monoxide (NO) sensor at low temperatures for air quality monitoring.

2 October 2018 in Materials
Verified
Journal Article
Open access
PDF file
TSThomas Stoecker
Thomas Stoecker
Ralf MoosRalf Moos
Ralf Moos
Oxide-based materials are promising candidates for use in high temperature thermoelectric generators. While their thermoelectric performance is inferior to commonly used thermoelectrics, oxides are environmentally friendly and cost-effective. In this study, Cu-based delafossites (CuFeO2), a material class with promising thermoelectric properties at high temperatures, were investigated. This work focuses on the phase stability of CuFeO2 with respect to the temperature and the oxygen partial pressure. For this reason, classical material characterization methods, such as scanning electron microscopy, energy dispersive X-ray spectroscopy, and X-ray diffraction, were combined in order to elucidate the phase composition of delafossites at 900 °C at various oxygen partial pressures. The experimentally obtained results are supported by the theoretical calculation of the Ellingham diagram of the copper–oxygen system. In addition, hot-stage X-ray diffraction and long-term annealing tests of CuFeO2 were performed in order to obtain a holistic review of the phase stability of delafossites at high temperatures and varying oxygen partial pressure. The results support the thermoelectric measurements in previous publications and provide a process window for the use of CuFeO2 in thermoelectric generators.

1 March 2018 in Solid State Ionics
Verified
Journal Article
Closed access
MBMurat Bektas
Murat Bektas
TSThomas Stoecker
Thomas Stoecker
GHGunter Hagen
Gunter Hagen
Ralf MoosRalf Moos
Ralf Moos