In this study, we present an innovative environmental silicon-, phosphorus-, and nitrogen-triple lignin-based flame retardant (Lig-K-DOPO). Lig-K-DOPO was successfully prepared by condensation of lignin with flame retardant intermediate DOPO-KH550 synthesized via Atherton-Todd reaction between 9, 10-dihydro-9-oxa-10-phosphaphenanthrene-10-oxide (DOPO) and γ-aminopropyl triethoxysilane (KH550A). The presence of silicon, phosphate, and nitrogen groups was characterized by FTIR, XPS, and 31P NMR spectroscopy. Lig-K-DOPO exhibited advanced thermal stability compared with pristine lignin supported by TGA analysis. The curing characteristic measurement showed that addition of Lig-K-DOPO promoted the curing rate and crosslink density to styrene butadiene rubber (SBR). Moreover, the cone calorimetry results indicated Lig-K-DOPO conferred impressive flame retardancy and smoke suppression. The addition of 20 phr Lig-K-DOPO reduced SBR blends 19.1% peak heat release rate (PHRR), 13.2% total heat release (THR), 53.2% smoke production rate (SPR), and 45.7% peak smoke production rate (PSPR). This strategy provides insights into multifunctional additives and greatly extends the comprehensive utilization of industrial lignin.
The viscoelastic behavior and reinforcement mechanism of polyethylene glycol (PEG) as an interfacial modifier in green tire tread composites were investigated in this study. The results show a clear positive effect on overall performance, and it significantly improved all the parameters of the “magic triangle” properties, the abrasion resistance, wet grip and ice traction, as well as the tire rolling resistance, simultaneously. For the preparation of the compounds, two mixing steps were used, as PEG 4000 was added on the second stage in order to avoid the competing reaction between silica/PEG and silanization. Fourier transform infrared spectroscopy (FTIR) confirmed that PEG could cover the silanol groups on the silica surface, resulting in the shortening of cure times and facilitating an increase of productivity. At low content of PEG, the strength was enhanced by the improvement of silica dispersion and the slippage of PEG chains, which are chemically and physically adsorbed on silica surface, but the use of excess PEG uncombined with silica in the compound, i.e., 5 phr, increases the possibility to shield the disulfide bonds of bis(3-(triethoxysilyl)-propyl) tetrasulfide (TESPT), and, thus, the properties were deteriorated. A constrained polymer model was proposed to explain the constrained chains of PEG in the silica-loaded composites on the basis of these results. An optimum PEG content is necessary for moderately strong matrix–filler interaction and, hence, for the enhancement in the mechanical properties.
26 October 2022 in Journal of Vinyl and Additive Technology