Manure and digestate liquid fractions are nutrient-rich effluents that can be fractionated and concentrated using membranes. However, these membranes tend to foul due to organic matter, solids, colloids, and inorganic compounds including calcium, ammonium, sodium, sulfur, potassium, phosphorus, and magnesium contained in the feed. This review paper is intended as a theoretical and practical tool for the decision-making process during design of membrane-based systems aiming at processing manure liquid fractions. Firstly, this review paper gives an overview of the main physico-chemical characteristics of manure and digestates. Furthermore, solid-liquid separation technologies are described and the complexity of the physico-chemical variables affecting the separation process is discussed. The main factors influencing membrane fouling mechanisms, morphology and characteristics are described, as well as techniques covering membrane inspection and foulant analysis. Secondly, the effects of the feed characteristics, membrane operating conditions (pressure, cross-flow velocity, temperature), pH, flocculation-coagulation and membrane cleaning on fouling and membrane performance are presented. Finally, a summary of techniques for specific recovery of ammonia-nitrogen, phosphorus and removal of heavy metals for farm effluents is also presented.
1 November 2020 in Chemical Engineering and Processing - Process Intensification
Biogas plant digestate liquid fractions can be concentrated by microfiltration and ultrafiltration. Two types of microfiltration membranes (polysulphone (PS) and surface-modified polyvinylidene fluoride (PVDF)) were used to process digestate liquid fractions, and to assess their applicability in the recovery of particulate phosphorus, compared to an ultrafiltration membrane (polyethersulphone (PES)). Results show that membrane material, operational conditions, and pore diameter influenced the permeate flux pattern during microfiltration. The PS membranes initially had a higher tendency to foul than PVDF membranes. However, during the filtration process, as fouling built up, the permeate flux behavior of the two membranes became very similar. During the concentration of digestate liquid fractions, the microfiltration PS membrane and the ultrafiltration PES membrane achieved the highest phosphorus rejection (80% w/w), suggesting that there was a correlation between the membrane material and both the fouling trend and phosphorus rejection. A two-step basic-acidic cleaning was unable to recover the initial water flux for the fouled microfiltration membranes. In conclusion, the PS microfiltration membranes might be a good strategy for recovering phosphorus from digestate liquid fractions. Further research leading to adequate cleaning procedures, for microfiltration PS and PVDF membranes treating digestate liquid fractions though, are needed.
Swine manure is a valuable source of nitrogen, phosphorus and potassium. After solid–liquid separation, the resulting swine wastewater can be concentrated by reverse osmosis (RO) to produce a nitrogen–potassium rich fertilizer. However, swine wastewater has a high fouling potential and an efficient cleaning strategy is required. In this study, a semi-commercial farm scale RO spiral-wound membrane unit was fouled while processing larger volumes of swine wastewater during realistic cyclic operations over a 9-week period. Membrane cleaning was performed daily. Three different cleaning solutions, containing SDS, SDS+EDTA and NaOH were compared. About 99% of the fouling resistance could be removed by rinsing the membrane with water. Flux recoveries (FRs) above 98% were achieved for all the three cleaning solutions after cleaning. No significant differences in FR were found between the cleaning solutions. The NaOH solution thus is a good economical option for cleaning RO spiral-wound membranes fouled with swine wastewater. Soaking the membrane for 3 days in permeate water at the end of each week further improved the FR. Furthermore, a fouling resistance model for predicting the fouling rate, permeate flux decay and cleaning cycle periods based on processing time and swine wastewater conductivity was developed.