Three-dimensional graphene architectures in the macroworld can in principle maintain all the extraordinary nanoscale properties of individual graphene flakes. However, current 3D graphene products suffer from poor electrical conductivity, low surface area and insufficient mechanical strength/elasticity; the interconnected self-supported reproducible 3D graphenes remain unavailable. Here we report a sugar-blowing approach based on a polymeric predecessor to synthesize a 3D graphene bubble network. The bubble network consists of mono- or few-layered graphitic membranes that are tightly glued, rigidly fixed and spatially scaffolded by micrometre-scale graphitic struts. Such a topological configuration provides intimate structural interconnectivities, freeway for electron/phonon transports, huge accessible surface area, as well as robust mechanical properties. The graphene network thus overcomes the drawbacks of presently available 3D graphene products and opens up a wide horizon for diverse practical usages, for example, high-power high-energy electrochemical capacitors, as highlighted in this work.
We report a facile one-step chemical method to synthesize partially reduced TiO2 nanotube arrays (NTAs). The NaBH4 treatment introduces oxygen vacancies on the surface and interior of TiO2. Oxygen vacancy extends the photocatalytic activity of TiO2 NTAs from the UV to visible light region, and enhances the electrical conductivity as well as charge transportation. Surface oxygen vacancies serve as charge carrier traps as well as adsorption sites where the charge transfer to adsorbed species inhibits the surface charge recombination, whereas bulk oxygen vacancies tend to act as charge carrier traps where e–h recombination occurs. The optimally reduced TiO2 NTAs yield a photocurrent density of 0.73 mA cm−2 at 1.23 VRHE and a highest photoconversion efficiency of 1.31% at a rather low bias of 0.40 VRHE under a standard AM 1.5G solar illumination. Not only does the incident photon to current conversion efficiency (IPCE) spectrum increase in the UV region, but photoactivity in visible light also emerged. Surface oxygen vacancies, serving as electron donors, cause a noticeable negative flatband shift and increase the donor density of TiO2 NTAs 2-fold. Electron paramagnetic resonance (EPR) spectra confirm the presence of oxygen vacancies on the surface and interior of TiO2. Benefitting from the oxygen vacancy, a narrowed band gap of 2.46 eV and suitable localized states for hydrogen production are observed.
Carbon materials doped with transition metal and nitrogen are highly active, non-precious metal catalysts for the electrochemical conversion of molecular oxygen in fuel cells, metal air batteries, and electrolytic processes. However, accurate measurement of their intrinsic turn-over frequency and active-site density based on metal centres in bulk and surface has remained difficult to date, which has hampered a more rational catalyst design. Here we report a successful quantification of bulk and surface-based active-site density and associated turn-over frequency values of mono- and bimetallic Fe/N-doped carbons using a combination of chemisorption, desorption and 57Fe Mössbauer spectroscopy techniques. Our general approach yields an experimental descriptor for the intrinsic activity and the active-site utilization, aiding in the catalyst development process and enabling a previously unachieved level of understanding of reactivity trends owing to a deconvolution of site density and intrinsic activity.