The direct and indirect radiation forcing of aerosol particles deeply affect the energy budget and the atmospheric chemical and physical processes. To retrieve the vertical aerosol mass fluxes and to investigate the vertical transport process of aerosol by a coherent Doppler lidar (CDL), a practical method for instrumental calibration and aerosol optical properties retrieval based on CDL and sun photometer synchronization observations has been developed. A conversion of aerosol optical properties to aerosol microphysical properties is achieved by applying a well-developed algorithm. Furthermore, combining the vertical velocity measured simultaneously with a CDL, we use the eddy covariance (EC) method to retrieve the vertical turbulent aerosol mass fluxes by a CDL and sun photometer with a spatial resolution of 15 m and a temporal resolution of 1 s throughout the planetary boundary layer (PBL). In this paper, we present a measurement case of 24-h continuous fluxes observations and analyze the diurnal variation of the vertical velocity, the aerosol backscatter coefficient at 1550 nm, the mean aerosol mass concentration, and the vertical aerosol mass fluxes on 13 April 2020. Finally, the main relative errors in aerosol mass flux retrieval, including sample error , aerosol optical properties retrieval error , and error introduced from aerosol microphysical properties retrieval algorithm , are evaluated. The sample error is the dominating error which increases with height except during 12:00–13:12 LST. The aerosol optical properties retrieval error is 21% and the error introduced from the aerosol microphysical properties retrieval algorithm is less than 50%.
13 February 2024 in Geo-spatial Information Science
Lidar can provide three-dimensional detection of the subsurface layer of the global ocean and represents the future direction of ocean remote sensing. One equation and two unknowns in elastic scattering lidar greatly affect the inversion accuracy. Based on airborne oceanographic lidar and in-situ measurements, an error analysis of widely used profile parameter inversion methods was performed, and a high-precision inversion method was developed. After careful data preprocessing, error analysis was performed on bio-optical parameters obtained from inversion methods including Collis Slope method, Klett backscatter iteration method, Churnside perturbation retrieval method and empirical models. In response to the inversion accuracy problems, a parameters optimization method has been proposed that does not require the assumption of a lidar ratio or a constant of lidar attenuation coefficient. Inversion results from the airborne lidar under the conditions of Case I waters in the South China Sea show that the method effectively improves the inversion accuracy of the β(π) profile to about 10% at depths over 50 m where the bio-optical parameters underwater change rapidly, and it can avoid misjudging the subsurface phytoplankton layer. Through detailed data preprocessing, profile parameter inversion and error analysis, this study provides a theoretical foundation for the development of future spaceborne oceanographic lidar data products.