In this study, we investigated the antimicrobial effects of plasma activated fine droplet (PAD) produced from arc discharge plasma on planktonic Listeria monocytogenes and Escherichia coli O157:H7. NaCl (0.9%, w/v) was used as the feeding solution for the plasma discharge. The inactivation mechanism of the PAD treatment was also investigated. PAD mainly contains H ₂ O ₂ and OCl ⁻ , which play a significant role in the inactivation process against L. monocytogenes and E. coli O157:H7. The population of L. monocytogenes and E. coli O157:H7 was significantly reduced by approximately 3 and 4 log units, respectively, within 5 min of exposure to PAD. However, the bactericidal effects of PAD against L. monocytogenes and E. coli O157:H7 showed different trends by showing 0.58 and 4.13 log reductions, respectively, after 1 min of PAD exposure time. The change of membrane integrity was evaluated using two DNA-binding fluorescence dyes, SYTO 9 and propidium iodide (PI). The breakage of the cell wall and membrane of both microorganisms was evidenced by the uptake of PI by cells after 5 min of exposure to PAD, but the effect was less in L. monocytogenes compared to E. coli O157:H7 after 1 min of PAD exposure time. The transmission electron microscopy results clearly showed morphological changes in both microorganisms, including denaturation or leakage of intracellular materials as a consequence of PAD treatment. These findings suggest that PAD-induced chemical species can eventually affect the intracellular materials of bacterial cells by passing through or attacking the cell envelope. In addition, L. monocytogenes are less susceptible to PAD compared with E. coli O157:H7.

In this work, we studied the control of plasma-produced species under a fixed gas composition (i.e., ambient air) in a 10 kHz-driven array-type dielectric barrier atmospheric-pressure plasma discharge. Instead of the gas composition, only the gas velocity was controlled. Thus, the plasma-maintenance cost was considerably lower than methods such as external N₂ or O₂ injection. The plasma-produced species were monitored using Fourier transformed infrared spectroscopy. The discharge properties were measured using a voltage probe, current probe, infrared camera, and optical emission spectroscopy. The results showed that the major plasma products largely depend on the gas temperature in the plasma discharge layer. The gas temperature in the plasma discharge layer was significantly different to the temperature of the ceramic adjacent to the plasma discharge layer, even in the small discharge power density of ∼15 W/cm² or ∼100 W/cm³. Because the vibrational excitation of N₂ was suppressed by the higher gas flow, the major plasma-produced species shifted from NOx in low flow to O₃ in high flow.

Atmospheric plasmas have been applied for the inactivation of microorganisms. Industrials demand to investigate the relation of the key reactive species induced by plasmas and the operating parameters including boundary conditions in order to control plasma treatment processes. In this study, we investigated the effect of gap distance between a pin-electrode and water surface on inactivation efficacy. When the gap distance decreased from 5 mm to 1 mm, the reduction of Escherichia coli (E. coli) was increased to more than 4 log CFU/mL. The reactive oxygen species measured optically and spectrophotometrically were influenced by gap distance. The results from electron spin resonance (ESR) analysis showed that the pin-to-water plasma generated hydroxyl radical (OH•) and singlet oxygen (¹O₂) in the water and superoxide radical (O₂⁻•) served as a precursor of OH•. The inactivation of E. coli was significantly alleviated by sodium azide (¹O₂ scavenger), indicating that ¹O₂ contributes the most to bacterial inactivation. These findings provide a potentially effective strategy for bacterial inactivation using a pin-to-water plasma.