This paper describes the preparation and the photoelectrochemical performances of visible light driven photoanodes based on novel r-GO/β-Cu2V2O7/TiO2 nanorods/composites. β-Cu2V2O7 was deposited on both fluorine doped tin oxide (FTO) and TiO2 nanorods (NRs)/FTO by a fast and convenient Aerosol Assisted Spray Pyrolysis (AASP) procedure. Ethylenediamine (EN), ammonia and citric acid (CA) were tested as ligands for Cu2+ ions in the aerosol precursors solution. The best-performing deposits, in terms of photocurrent density, were obtained when NH3 was used as ligand. When β-Cu2V2O7 was deposited on the TiO2 NRs a good improvement in the durability of the photoanode was obtained, compared with pure β-Cu2V2O7 on FTO. A further remarkable improvement in durability and photocurrent density was obtained upon addition, by electrophoretic deposition, of reduced graphene oxide (r-GO) flakes on the β-Cu2V2O7/TiO2 composite material. The samples were characterized by X-ray Photoelectron Spectroscopy (XPS), Raman, High Resolution Transmission Electron Microscopy (HR-TEM), Scanning Electron Microscopy (SEM), Wide Angle X-ray Diffraction (WAXD) and UV-Vis spectroscopies. The photoelectrochemical (PEC) performances of β-Cu2V2O7 on FTO, β-Cu2V2O7/TiO2 and r-GO/β-Cu2V2O7/TiO2 were tested in visible light by linear voltammetry and Electrochemical Impedance Spectroscopy (EIS) measurements.
The wide band gap of TiO2 hinders the utilization of visible light in high-performance photocatalysis. Herein, vertically aligned Ti nanopillar arrays (NPAs) were grown by the glancing angle deposition method (GLAD) and then thermally oxidized into TiO2 NPAs. The metallic nanoparticles (NPs) were fabricated by successive ion layer adsorption and reaction (SILAR) method. And we covered ultrathin TiO2 layer on Au/Pt NPs decorated NPA using atomic layer deposition (ALD) method and did annealing process in the end. The photoelectrochemical (PEC) performance and dye degradation have been studied. We find the dye degradation efficiency of best combination reaches up to 1.5 times higher than that of original Au/Pt-TiO2 sample under visible light irradiation. The TiO2 ALD layer effectively protects the nanostructure from corrosion and helps the transmission of electrons to the electrolyte. By controlling the annealing temperature we could achieve a matched band gap due to change in noble metal particle size. Our work demonstrates that rational design of composite nanostructures enhances the usage of broader wavelength range light and optimizes photocatalytic degradation of organic pollutants in practical applications.