Soil gas measurements of radon (²²²Rn), CO₂, and hydrocarbon concentrations, as well as gamma-ray spectrometry, were conducted at two separate locations to estimate the measurement results for known locations of hydrocarbon accumulations in the subsurface and oil seepage on the surface. The aim of the study was to confirm the applicability of the method for identifying migration pathways (e.g., faults) and to detect possible seepages of hydrocarbons to the surface as well as to investigate possible health issue potential about the soil gas analysis results. Site A investigations were performed with a large number of sampling points to provide sufficient spatial coverage to capture the influence of subsurface lithologic variability as well as the influence of the migration pathway on the measured parameters. For the investigation of site B, sampling points were positioned to reflect the situation between the area above producing hydrocarbon fields and areas with no confirmed accumulation. The results presented show that it is possible to distinguish the near-surface lithology (gamma-ray spectrometry), characterize the migration pathway, and indicate the area of oil seepage at the surface. Areas above the known hydrocarbon accumulations generally have elevated radon concentrations and detectable heavier hydrocarbons with sporadic methane in soil gas, which contrasts with the lower radon levels and lack of detectable heavier hydrocarbons in soil gas in the area with no confirmed hydrocarbon accumulation in the subsurface.

The thick Lake Pannon sedimentary record provides insights into the downdip and lateral development of stratigraphic surfaces through the analysis of the basin-scale clinoform progradation. The clinoform architecture from the eastern part of the Drava Basin (Pannonian Basin System) was interpreted to reflect the base-level changes. A major downlap surface interpreted as a flooding event followed by rejuvenation of slope progradation was recognized on 2D seismic sections. Detailed 3D seismic interpretation combined with well data revealed that the large sigmoidal and the overlying small oblique clinoform sets that downlap the large one only apparently produce the geometry of a maximum flooding surface. Instead, the 3D mapping revealed the influence of two competing slope systems arriving from the north and northwest. Lateral switching of sediment input, similar to many recent deltaic systems. e.g., Danube and Po rivers led to the variability of stratigraphic surfaces, lithology, and thickness, which resulted in non-uniform shelf-edge migration. These observations were supported by forward stratigraphic modeling simulating different scenarios, which led to the generation of the depositional architecture with an apparent maximum flooding surface. This study also implies the potential pitfalls in basin analysis based only on scarce 2D seismic and emphasizes the role of lateral variations in sediment input controlling the depositional architecture.

After the earthquake of 29/12/2020 in Petrinja (ML6.2, ImaxVIII-IX EMS), an attempt was made to characterize the active structure associated with the earthquake. As a first step towards this goal, we performed a geomorphological analysis in order to contribute to the identification and characterization of the surface expression of the active Pokupsko dextral strike-slip fault. We focused on the area between the southernmost parts of Vukomeričke Gorice and the southernmost parts of Hrastovica Mountain, where the NW-SE striking Pokupsko fault has slipped during and after the recent earthquake (Ganas et al., 2021). Using available 1 : 5 000 scale topographic maps and various 10 m resolution digital elevation model visualizations, we mapped lineaments that could represent relatively recently active fault segments. We used a quantitative approach to perform stream sinuosity analysis (e.g., Leopold et al., 1964; Zamolyi et al., 2010) on major streams crossing the structure to identify distinct changes in channel patterns that may be associated with vertical movement along the predominantly strike-slip fault. We observed changes in the shape of the valleys, especially the changes in width, height, and direction. By summarizing various geomorphological indicators of active fault segmentation at the surface with available geological data (Pikija, 1987) and so far limited field observations, we provide insights into the structure of the Pokupsko fault.Preliminary results show good agreement between lineament mapping, changes in valley shape, changes in the stream sinuosity index, and (to some extent) previously mapped faults. In addition, some of the changes in stream sinuosity correspond to locations where coseismic surface ruptures occurred during the December 29 earthquake (Budić et al., this session; Pollak et al., 2021). Results suggest that the several-kilometer-wide zone of uplifted Neogene deposits results from the dextral-transpressive structure, which at the surface consists of a series of subparallel fault strands branching off the main fault that runs along the SE slopes of the Hrastovica Mountain. The SW-most fault strands are associated with significant changes in the shape of the valleys: the wide valleys of Petrinjčica, Utinja and Šanja change to narrow and deeply incised as they cross the uplifted structure. Paleocene and Eocene rocks, which otherwise underlie the Neogene, outcrop in the NE parts of the fluvial breakthrough valleys, indicating the uplift of the Hrastovica Mountain. Topographic data show a decrease of the mountain range elevation towards the SW. This evidence suggests that the main fault runs on the NE side of the mountain, strikes NW-SE and dips steeply towards the SW. The fault strike deviates between Župić and Farkašić. The fault plane solution for the December 29 earthquake suggests a nearly pure strike-slip fault, while geomorphic evidence strongly indicates areas of active uplift along the fault, further supported by the general antiformal structure. We interpret this as an indication of either a general current transpressional character of the fault or as local kinematic variations due to segmentation and changes in the strike of the fault; further analyses are pending.

The 2020 Mw 6.4 Petrinja earthquake in central Croatia is one of the European strongest continental earthquakes in recent decades. This event shed light on the poorly investigated Petrinja-Pokupsko Fault (PPKF) zone, a right-lateral fault system accommodating a fraction of the shortening between the Adria and European plates. Through field observations and high-resolution Lidar-derived digital elevation models of the central section of the PPKF, we precisely mapped the fault trace, revealing a discontinuous geometry with a main fault strand and left-stepping segments in agreement with the position of the 2020 surface ruptures. To the north, the accumulated relief from this transpressive fault system decreases, and the fault trace becomes less distinct, suggesting a northward propagation of the deformation. Cumulative offsets of 4 to 24 meters along the main fault strands in the central and southern sections of the fault attest to its Quaternary activity. Dating results suggest offset markers at the Marine Isotopic Stage 4 (MIS 4), the Late Glacial Maximum (LGM) or the Early Holocene periods, allowing for the first direct estimation of the fault slip rates. Preliminary estimates indicate that, assuming a common MIS 4 or LGM age for the investigated markers, fault slip rates range from 0.2 to 0.7 mm/yr and 0.7 to 1.6 mm/yr, respectively. In contrast, assigning Early Holocene ages would imply much higher - and likely unrealistic - slip rates of 1.6 to 3.9 mm/yr. Although the estimated loading rates vary greatly and depend on strong assumptions regarding the age of the markers abandonment, our results suggest a minimum fault slip-rate of 0.2 mm/yr for local seismic hazard assessments.