Over the last two decades, oxide nanostructures have been continuously evaluated and used in many technological applications. The advancement of the controlled synthesis approach to design desired morphology is a fundamental key to the discipline of material science and nanotechnology. These nanostructures can be prepared via different physical and chemical methods; however, a green and ecofriendly synthesis approach is a promising way to produce these nanostructures with desired properties with less risk of hazardous chemicals. In this regard, ZnO and TiO2 nanostructures are prominent candidates for various applications. Moreover, they are more efficient, non-toxic, and cost-effective. This review mainly focuses on the recent state-of-the-art advancements in the green synthesis approach for ZnO and TiO2 nanostructures and their applications. The first section summarizes the green synthesis approach to synthesize ZnO and TiO2 nanostructures via different routes such as solvothermal, hydrothermal, co-precipitation, and sol-gel using biological systems that are based on the principles of green chemistry. The second section demonstrates the application of ZnO and TiO2 nanostructures. The review also discusses the problems and future perspectives of green synthesis methods and the related issues posed and overlooked by the scientific community on the green approach to nanostructure oxides.
As-etched macroporous silicon layers were passivated successful by electrochemical oxidation and then covered by a chemically deposited polyaniline layer. They were studied by Fourier transform infrared spectroscopy (FTIR) and Impedance electrochemical spectroscopy (IES). The results show that electrochemical method is an excellent alternative for silicon oxide growth within the porous structure, whereas for polyaniline deposition into the insulating structure the chemical route is the most suitable. The FTIR analysis reveals that polyaniline in its emeraldine state, which is the most conductive one, was successful deposited into the porous matrix. The electrochemical behavior of these samples was studied by the impedance electrochemical spectroscopy (IES) and shows that IES is sensitive to surface chemical properties variation at the film/electrolyte interface, as well as to the chemical composition of the electrolyte. The addition of low amounts of contaminants, in the order of ppb, promotes a shift of its real and imaginary impedance, showing that these samples can be used as excellent chemosensor for contaminants in ethanoic solution.
Nanostructured materials have emerged as valuable tools for the advancement of novel electrocatalysts. Among them, three-dimensional metal oxides have gained significant attention due to their excellent conductivity, cost-effectiveness, and unique design. This study focuses on the synthesis of cotton-like three-dimensional antimony oxychloride (Sb4O5Cl2) structures through a straightforward precipitation method. The nanostructures exhibit immense potential for sensing applications. Electrochemical characterization reveals that the Sb4O5Cl2 heterostructure demonstrates a remarkable double-layer capacitance of 662 F/cm(2), accompanied by excellent cyclic stability. The sensor's performance was tested for the detection of ammonium hydroxide (HA) in NaCl solution, yielding sensitivities ranging from 0.95 to 0.140 mA mM(-1) cm(-2) and a detection limit of 4.54 mu M within a wide detection range of 0.3-250 mM. The sensor device possesses a distinctive cotton-like structure and is synthesized through a simple and cost-effective route.
Porous silicon monolayers with different porosities were produced by etching p-type crystalline silicon (c-Si) in HF-based electrolytes. Mesoporous structures were achieved in heavily doped c-Si anodized into HF:ethanol, whereas for macroporous ones slightly doped c-Si was etched in HF and dimethylformamide solution. After electrochemical oxidation of them, it was found that depending on both the porosity and remaining cSi size, the thickness of them becomes contracted, while the reduction of the effective refractive index (ERI) is associated to the presence of silicon oxide within the structures. The optical reflectance of the as-etched, oxidized and polymer deposited macroporous silicon shows that they are excellent materials for sensor and photovoltaic application.