Oil pollution has been a worldwide concern especially in environments where treatment is quite difficult to apply. Marine polluted sediments, in particular, constitute one of the most recalcitrant environments for bioremediation and are often the final repository of petroleum contaminants, as a result of runoff and deposition. Aerobic hydrocarbon degraders present in the sediments are tackling the pollution under oxygen-limited or oxygen-depleted conditions. Research has focused on new ways to enhance bioremediation under anoxic conditions, however aerobic bioremediation is faster, and hence more effort should be made to sustain oxygen concentration levels. In this review, the different bioremediation techniques used for the decontamination of marine sediments are briefly discussed, and focus is primarily given to the different oxygenation methods used for enhancing aerobic bioremediation and the aeration methods that are suitable for in situ application, as well as state of the art technologies that make in situ aeration an appealing approach. Based on the technologies analyzed, suggestions are made for sediment bioremediation techniques in different marine environments.

The diversity and degradation capacity of hydrocarbon-degrading consortia from surface and deep waters of the Eastern Mediterranean Sea were studied in time-series experiments. Microcosms were set up in ONR7a medium at in situ temperatures of 25 °C and 14 °C for the Surface and Deep consortia, respectively, and crude oil as the sole source of carbon. The Deep consortium was additionally investigated at 25 °C to allow the direct comparison of the degradation rates to the Surface consortium. In total, ~50% of the alkanes and ~15% of the polycyclic aromatic hydrocarbons were degraded in all treatments by Day 24. Approximately ~95% of the total biodegradation by the Deep consortium took place within 6 days regardless of temperature, whereas comparable levels of degradation were reached on Day 12 by the Surface consortium. Both consortia were dominated by well-known hydrocarbon-degrading taxa. Temperature played a significant role in shaping the Deep consortia communities with Pseudomonas and Pseudoalteromonas dominating at 25 °C and Alcanivorax at 14 °C. Overall, the Deep consortium showed a higher efficiency for hydrocarbon degradation within the first week following contamination, which is critical in the case of oil spills, and thus merits further investigation for its exploitation in bioremediation technologies tailored to the Eastern Mediterranean Sea.

Hydrocarbon biodegradation rates in the deep-sea have been largely determined under atmospheric pressure, which may lead to non-representative results. In this work, we aim to study the response of deep-sea microbial communities of the Eastern Mediterranean Sea (EMS) to oil contamination at in situ environmental conditions and provide representative biodegradation rates. Seawater from a 600 to 1000 m depth was collected using a high-pressure (HP) sampling device equipped with a unidirectional check-valve, without depressurization upon retrieval. The sample was then passed into a HP-reactor via a piston pump without pressure disruption and used for a time-series oil biodegradation experiment at plume concentrations, with and without dispersant application, at 10 MPa and 14 °C. The experimental results demonstrated a high capacity of indigenous microbial communities in the deep EMS for alkane degradation regardless of dispersant application (>70%), while PAHs were highly degraded when oil was dispersed (>90%) and presented very low half-lives (19.4 to 2.2 days), compared to published data. To our knowledge, this is the first emulation study of deep-sea bioremediation using undisturbed deep-sea microbial communities.