Cristina Prados-Roman

Dr. Cristina Prados-Roman

orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
22 January 2021 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
TVTijl Verhoelst
Tijl Verhoelst
SCSteven Compernolle
Steven Compernolle
GPGaia Pinardi
Gaia Pinardi
JLJean-Christopher Lambert
Jean-Christopher Lambert
HEHenk Eskes
Henk Eskes
CZClaus Zehner
Claus Zehner
This paper reports on consolidated ground-based validation results of the atmospheric NO2 data produced operationally since April 2018 by the TROPOspheric Monitoring Instrument (TROPOMI) on board of the ESA/EU Copernicus Sentinel-5 Precursor (S5P) satellite. Tropospheric, stratospheric, and total NO2 column data from S5P are compared to correlative measurements collected from, respectively, 19 Multi-Axis Differential Optical Absorption Spectroscopy (MAX-DOAS), 26 Network for the Detection of Atmospheric Composition Change (NDACC) Zenith-Scattered-Light DOAS (ZSL-DOAS), and 25 Pandonia Global Network (PGN)/Pandora instruments distributed globally. The validation methodology gives special care to minimizing mismatch errors due to imperfect spatio-temporal co-location of the satellite and correlative data, e.g. by using tailored observation operators to account for differences in smoothing and in sampling of atmospheric structures and variability and photochemical modelling to reduce diurnal cycle effects. Compared to the ground-based measurements, S5P data show, on average, (i) a negative bias for the tropospheric column data, of typically −23 % to −37 % in clean to slightly polluted conditions but reaching values as high as −51 % over highly polluted areas; (ii) a slight negative median difference for the stratospheric column data, of about −0.2 Pmolec cm−2, i.e. approx. −2 % in summer to −15 % in winter; and (iii) a bias ranging from zero to −50 % for the total column data, found to depend on the amplitude of the total NO2 column, with small to slightly positive bias values for columns below 6 Pmolec cm−2 and negative values above. The dispersion between S5P and correlative measurements contains mostly random components, which remain within mission requirements for the stratospheric column data (0.5 Pmolec cm−2) but exceed those for the tropospheric column data (0.7 Pmolec cm−2). While a part of the biases and dispersion may be due to representativeness differences such as different area averaging and measurement times, it is known that errors in the S5P tropospheric columns exist due to shortcomings in the (horizontally coarse) a priori profile representation in the TM5-MP chemical transport model used in the S5P retrieval and, to a lesser extent, to the treatment of cloud effects and aerosols. Although considerable differences (up to 2 Pmolec cm−2 and more) are observed at single ground-pixel level, the near-real-time (NRTI) and offline (OFFL) versions of the S5P NO2 operational data processor provide similar NO2 column values and validation results when globally averaged, with the NRTI values being on average 0.79 % larger than the OFFL values.

29 September 2016 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
TSTomás Sherwen
Tomás Sherwen
JSJohan A. Schmidt
Johan A. Schmidt
MEMat J. Evans
Mat J. Evans
LCLucy J. Carpenter
Lucy J. Carpenter
KGKatja Großmann
Katja Großmann
COCarlos Ordóñez
Carlos Ordóñez
We present a simulation of the global present-day composition of the troposphere which includes the chemistry of halogens (Cl, Br, I). Building on previous work within the GEOS-Chem model we include emissions of inorganic iodine from the oceans, anthropogenic and biogenic sources of halogenated gases, gas phase chemistry, and a parameterised approach to heterogeneous halogen chemistry. Consistent with Schmidt et al. (2016) we do not include sea-salt debromination. Observations of halogen radicals (BrO, IO) are sparse but the model has some skill in reproducing these. Modelled IO shows both high and low biases when compared to different datasets, but BrO concentrations appear to be modelled low. Comparisons to the very sparse observations dataset of reactive Cl species suggest the model represents a lower limit of the impacts of these species, likely due to underestimates in emissions and therefore burdens. Inclusion of Cl, Br, and I results in a general improvement in simulation of ozone (O3) concentrations, except in polar regions where the model now underestimates O3 concentrations. Halogen chemistry reduces the global tropospheric O3 burden by 18.6 %, with the O3 lifetime reducing from 26 to 22 days. Global mean OH concentrations of 1.28 × 106 molecules cm−3 are 8.2 % lower than in a simulation without halogens, leading to an increase in the CH4 lifetime (10.8 %) due to OH oxidation from 7.47 to 8.28 years. Oxidation of CH4 by Cl is small (∼ 2 %) but Cl oxidation of other VOCs (ethane, acetone, and propane) can be significant (∼ 15–27 %). Oxidation of VOCs by Br is smaller, representing 3.9 % of the loss of acetaldehyde and 0.9 % of the loss of formaldehyde.

1 April 2011 in Journal of Quantitative Spectroscopy and Radiative Transfer
Verified
Journal Article
Closed access
TDTim Deutschmann
Tim Deutschmann
SBSteffen Beirle
Steffen Beirle
UFUdo Frieß
Udo Frieß
MGMichael Grzegorski
Michael Grzegorski
CKChristoph Kern
Christoph Kern
KPKlaus Pfeilsticker
Klaus Pfeilsticker

2 February 2016 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
TST. Sherwen
T. Sherwen
MEM. J. Evans
M. J. Evans
LCL. J. Carpenter
L. J. Carpenter
SAS. J. Andrews
S. J. Andrews
RLR. T. Lidster
R. T. Lidster
COC. Ordóñez
C. Ordóñez
We present a global simulation of tropospheric iodine chemistry within the GEOS-Chem chemical transport model. This includes organic and inorganic iodine sources, standard gas-phase iodine chemistry, and simplified higher iodine oxide (I2OX, X = 2, 3, 4) chemistry, photolysis, deposition, and parametrized heterogeneous reactions. In comparisons with recent iodine oxide (IO) observations, the simulation shows an average bias of ∼ +90 % with available surface observations in the marine boundary layer (outside of polar regions), and of ∼ +73 % within the free troposphere (350 hPa < p < 900 hPa) over the eastern Pacific. Iodine emissions (3.8 Tg yr−1) are overwhelmingly dominated by the inorganic ocean source, with 76 % of this emission from hypoiodous acid (HOI). HOI is also found to be the dominant iodine species in terms of global tropospheric IY burden (contributing up to 70 %). The iodine chemistry leads to a significant global tropospheric O3 burden decrease (9.0 %) compared to standard GEOS-Chem (v9-2). The iodine-driven OX loss rate1 (748 Tg OX yr−1) is due to photolysis of HOI (78 %), photolysis of OIO (21 %), and reaction between IO and BrO (1 %). Increases in global mean OH concentrations (1.8 %) by increased conversion of hydroperoxy radicals exceeds the decrease in OH primary production from the reduced O3 concentration. We perform sensitivity studies on a range of parameters and conclude that the simulation is sensitive to choices in parametrization of heterogeneous uptake, ocean surface iodide, and I2OX (X = 2, 3, 4) photolysis. The new iodine chemistry combines with previously implemented bromine chemistry to yield a total bromine- and iodine-driven tropospheric O3 burden decrease of 14.4 % compared to a simulation without iodine and bromine chemistry in the model, and a small increase in OH (1.8 %). This is a significant impact and so halogen chemistry needs to be considered in both climate and air quality models. 1 Here OX is defined as O3 + NO2 + 2NO3 + PAN + PMN+PPN + HNO4 + 3N2O5 + HNO3 + BrO + HOBr + BrNO2+2BrNO3 + MPN + IO + HOI + INO2 + 2INO3 + 2OIO+2I2O2 + 3I2O3 + 4I2O4, where PAN = peroxyacetyl nitrate, PPN = peroxypropionyl nitrate, MPN = methyl peroxy nitrate, and MPN = peroxymethacryloyl nitrate.

16 January 2015 in Atmospheric Chemistry and Physics
Verified
Journal Article
Open access
PDF file
CPCristina Prados-Roman
Cristina Prados-Roman
CCCarlos Alberto Cuevas
Carlos Alberto Cuevas
THT. Hay
T. Hay
RFRafael Pedro Pedro Fernandez
Rafael Pedro Pedro Fernandez
AMA. S. Mahajan
A. S. Mahajan
ASAlfonso Saiz-Lopez
Alfonso Saiz-Lopez
Emitted mainly by the oceans, iodine is a halogen compound important for atmospheric chemistry due to its high ozone depletion potential and effect on the oxidizing capacity of the atmosphere. Here we present a comprehensive data set of iodine oxide (IO) measurements in the open marine boundary layer (MBL) made during the Malaspina 2010 circumnavigation. Results show IO mixing ratios ranging from 0.4 to 1 pmol mol−1 (30% uncertainty) and, complemented with additional field campaigns, this data set confirms through observations the ubiquitous presence of reactive iodine chemistry in the global marine environment. We use a global model with organic (CH3I, CH2ICl, CH2I2 and CH2IBr) and inorganic (HOI and I2) iodine ocean emissions to investigate the contribution of the different iodine source gases to the budget of IO in the global MBL. In agreement with previous estimates, our results indicate that, globally averaged, the abiotic precursors contribute about 75 % to the IO budget. However, this work reveals a strong geographical pattern in the contribution of organic vs. inorganic precursors to reactive iodine in the global MBL.

6 May 2020 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
KKKarin Kreher
Karin Kreher
MRMichel Van Roozendael
Michel Van Roozendael
FHFrancois Hendrick
Francois Hendrick
AAArnoud Apituley
Arnoud Apituley
EDErmioni Dimitropoulou
Ermioni Dimitropoulou
XZXiaoyi Zhao
Xiaoyi Zhao
In September 2016, 36 spectrometers from 24 institutes measured a number of key atmospheric pollutants for a period of 17 d during the Second Cabauw Intercomparison campaign for Nitrogen Dioxide measuring Instruments (CINDI-2) that took place at Cabauw, the Netherlands (51.97∘ N, 4.93∘ E). We report on the outcome of the formal semi-blind intercomparison exercise, which was held under the umbrella of the Network for the Detection of Atmospheric Composition Change (NDACC) and the European Space Agency (ESA). The three major goals of CINDI-2 were (1) to characterise and better understand the differences between a large number of multi-axis differential optical absorption spectroscopy (MAX-DOAS) and zenith-sky DOAS instruments and analysis methods, (2) to define a robust methodology for performance assessment of all participating instruments, and (3) to contribute to a harmonisation of the measurement settings and retrieval methods. This, in turn, creates the capability to produce consistent high-quality ground-based data sets, which are an essential requirement to generate reliable long-term measurement time series suitable for trend analysis and satellite data validation. The data products investigated during the semi-blind intercomparison are slant columns of nitrogen dioxide (NO2), the oxygen collision complex (O4) and ozone (O3) measured in the UV and visible wavelength region, formaldehyde (HCHO) in the UV spectral region, and NO2 in an additional (smaller) wavelength range in the visible region. The campaign design and implementation processes are discussed in detail including the measurement protocol, calibration procedures and slant column retrieval settings. Strong emphasis was put on the careful alignment and synchronisation of the measurement systems, resulting in a unique set of measurements made under highly comparable air mass conditions. The CINDI-2 data sets were investigated using a regression analysis of the slant columns measured by each instrument and for each of the target data products. The slope and intercept of the regression analysis respectively quantify the mean systematic bias and offset of the individual data sets against the selected reference (which is obtained from the median of either all data sets or a subset), and the rms error provides an estimate of the measurement noise or dispersion. These three criteria are examined and for each of the parameters and each of the data products, performance thresholds are set and applied to all the measurements. The approach presented here has been developed based on heritage from previous intercomparison exercises. It introduces a quantitative assessment of the consistency between all the participating instruments for the MAX-DOAS and zenith-sky DOAS techniques.