The back-end-of-line (BEOL) copper interconnect structure has been subjected to downscaling for the last two decades, while the materials used for conforming and assuring its physical integrity during processing have faced significant obstacles as the single-digit nanometer process node is implemented. In particular, the diffusion barrier layer system comprised of Ta/TaN has faced major constraints when it comes to the electrical performance of the smaller Cu lines, and thus alternative formulations have been investigated in recent years, such as Ru-Ta or Co-W alloys. In this work, we assess how PVD (physical vapor deposition) deposited equimolar Co-W films perform when exposed to different vacuum annealing temperatures and how these films compare with the Ta adhesion layer used for Cu seeding in terms of dewetting resistance. The stacks were characterized using scanning electron microscopy (SEM), X-ray diffraction (XRD), transmission electron microscopy (TEM) and scanning transmission electron microscopy (STEM) coupled with energy dispersive X-ray spectroscopy (EDX) mapping. The Cu film at the surface of the Cu/Co-W system exhibited grain growth starting at 300 °C, with the formation of abnormally large Cu grains starting at 450 °C. Sheet resistance reached a minimum value of 7.07 × 10−6 Ω/sq for the Cu/Co-W stack and 6.03 × 10−6 Ω/sq for the Cu/Ta stack, both for the samples annealed at 450 °C.
11 September 2018 in Journal of Superconductivity and Novel Magnetism
Direct Energy Deposition (DED) is a highly efficient technology for the manufacture and/or repair of different components for multiple industries, including aeronautical. However, a good understanding of the various process variables is essential for producing deposits with the desired properties and ensuring process efficiency. In this study, the optimisation of Inconel 718 single-track deposits was carried out by varying laser power, scanning speed, and powder feed rate to minimise dilution and maximise height, always ensuring the efficiency of the process. The influence of the DED process’ inputs (laser power, scanning speed, and feed rate) and outputs (deposit’s geometry and dilution) were evaluated in the construction of Response Surface Plots and regression analysis equations, allowing the selection of the most promising processing conditions that achieve high-quality single tracks, with predicted dilution percentage, and deposit height. Optimisation analysis selected process parameters, and a block with 300 × 50 × 3 mm3 was built. Mechanical and microstructural characterisation of the built block before and after heat treatment (homogenisation at 1080 °C, followed by solubilisation at 980 °C, and double ageing at 720 and 620 °C) was performed through Optical Microscopy, SEM/EDS analysis, Vickers hardness and tensile tests. It could be observed that the chosen process leads to the formation of a dendritic structure with considerable amounts of Laves phase. However, heat treatments make it possible to obtain a more homogeneous structure with higher amounts of hardening phases, such as γ’ and γ”, which promotes an increase in hardness and tensile strength, and partial elimination of the Laves phase. With proper optimisation of the DED process and understanding of the different parameters’ influence on the deposit’s microstructure, it is possible to manufacture or repair Inconel 718 components for several industries.