Non-doped as well as titanium and lutetium doped zirconia (ZrO2) materials were synthesized via the sol-gel method and structurally characterized with X-ray powder diffraction. The addition of Ti in the zirconia lattice does not change the crystalline structure whilst the Lu doping introduces a small fraction of the tetragonal phase. The UV excitation results in a bright white-blue luminescence at ca. 500 nm for all the materials which emission could be assigned to the Ti3+eg → t2g transition. The persistent luminescence originates from the same Ti3+ center. The thermoluminescence data shows a well-defined though rather similar defect structures for all the zirconia materials. The kinetics of persistent luminescence was probed with the isothermal decay curve analyses which indicated significant retrapping. The short duration of persistent luminescence was attributed to the quasi-continuum distribution of the traps and to the possibility of shallow traps even below the room temperature.
Persistent luminescence (PeL) materials find many applications nowadays, such as in emergency lighting, medical imaging, and enhancement of solar cell devices. However, the majority of PeL materials are synthesized by time- and energy-consuming processes such as conventional solid-state methods. Here, a series of Ti-doped RE2O2S materials (RE: La, Gd, and Y) were successfully prepared by an energy-saving microwave-assisted solid-state synthesis. This versatile method allows obtaining oxysulfide materials starting from primary precursors (e.g. oxides and elemental sulfur) in a one-step 25 minute process. The PeL materials were characterized using synchrotron radiation X-ray powder diffraction (SR-XPD), scanning electron microscopy (SEM), X-ray absorption spectroscopy (SR-XAS), and infrared absorption spectroscopy (FTIR), and the spectroscopic properties were studied using photoluminescence spectroscopy (PL) and thermoluminescence (TL). SR-XAS at the sulfur K-edge of RE2O2S suggests that elemental sulfur (S0) is oxidized in a first step forming sulfate-like (SVI) species, then is gradually reduced to form oxysulfide (S2−). The RE2O2S:Ti,Mg2+ materials show a broad emission band in the orange-red spectral region, assigned to the transitions of Ti3+/TiIV ions. The persistent luminescence of the Gd and Y2O2S:Ti,Mg2+ materials is long-lasting, being visible for ca. 5 h with the naked eye. Lastly, these photonic materials were shown to act as emitting layers for PeL warm white-LEDs, presenting great potential for applications such as self-sustained security lighting.
Ultraviolet-visible to near-infrared quantum cutting (QC) materials are a promising tool to enhance the efficiency of conventional crystalline silicon solar cells. The spectroscopic properties of Tb3+–Yb3+ co-doped ZrO2 nanocrystals are presented, and the QC mechanisms in these nanocrystals are investigated. The materials were fabricated using the sol gel method and characterized using X-ray powder diffraction, X-ray absorption near edge structure, and luminescence spectroscopy. The incorporation of Yb3+ ions into the host induced a crystalline phase change of ZrO2 from monoclinic to tetragonal to cubic symmetry and influenced the Tb valence state. The Tb3+ visible emission, excitation intensity (monitored by the Tb3+:5D4 emission), decay time of the Tb3+:5D4 emitter level, and down-conversion (DC) emission intensity increased with Yb3+ concentration. Furthermore, a sublinear dependence of the DC intensity on the excitation power at the Tb3+:5D4 level indicated the coexistence of two different QC mechanisms from Tb3+ → Yb3+. The first one is a linear process in which one Tb3+ ion transfers its energy simultaneously to two Yb3+ ions, known as cooperative energy transfer, and the second one is a non-linear process involving an intermediated virtual level in the Tb3+ ion.