This in vitro study aimed to quantify the penetration of hydrogen peroxide (HP) into the pulp chamber in teeth submitted to in-office bleaching with varied pH and application techniques. The color change and pH of the in-office bleaching product during application was also evaluated. Ninety-six human premolars were used and randomly divided into 10 groups (n=9) according to the following combination of factors: pH of in-office bleaching agents (two neutral/alkaline pH: Opalescence Boost 38% and Whiteness HP Blue 35% and three acidic pH: Whiteness HP Maxx 35%, Lase Peroxide Sensy 35%, and Total Blanc Office 35%) and application modes (for 3 × 15 minutes [3×15] and 1 × 45 minutes [1×45]). An additional group of non-bleached teeth (control; n=6) was added. First, all teeth were sectioned 3 mm from the cementoenamel junction and the pulp tissue was removed. An acetate buffer was placed in the pulp chamber of all teeth. After bleaching, this solution was transferred to a glass tube in which HP was allowed to react with other components, resulting in a pink solution. The optical density of this pink solution was measured using ultraviolet-visible spectroscopy and converted into amount of HP. Color change before and 1 week after bleaching was evaluated using a digital spectrophotometer. A pH meter with a 6-mm circular and flat surface was used in contact with the enamel surface to quantify the pH of the bleaching gels during application. Data were analyzed using two-way analysis of variance and Tukey tests (α=0.05). Overall, lower mean HP penetration values were observed for Opalescence Boost 38% and Whiteness HP Blue 35% compared with other bleaching gels (p0.05). However, lower mean HP penetration values were observed for Whiteness HP Maxx 35%, Total Blanc Office 35%, and Lase Peroxide Sensy 35% when using the 3×15 application technique compared with the 1×45 technique (p0.54). The pH did not change during the 3×15 application technique; however, all acidic bleaching gels significantly decreased in pH when applied for 1×45 (p<0.01). The amount of HP that reaches the pulp chamber was lower when neutral/alkaline pH gels were used, independently of the application technique. When considering acidic pH gels, it is preferable to use the 3×15 application technique, mainly because longer application time (1×45) results in lower pH. No difference was observed between groups with regards to color change.

The aim of the present study was to evaluate the influence of several experimental pretreatment crosslinker solutions on the resin polymer–dentine interface created using a representative universal adhesive system, by means of microtensile bond strength testing (μTBS), nanomechanical properties and ultramorphology confocal laser scanning microscopy (CLSM). Five experimental solutions containing different flavonoids were applied as dentine pretreatment after acid etching. A control pretreatment group containing no flavonoid was also employed. A representative modern universal adhesive was then applied, followed by a 3 mm thick composite built up. Specimens were sectioned into sticks and submitted to a μTBS test or nanoindentation analysis along the interface (24 h or 25,000 thermocycles). The ultramorphology of the polymer–resin interface was also evaluated using CLSM. The results were analyzed using two-way ANOVA and Bonferroni’s post hoc test (α = 0.05). All flavonoids improved short- and long-term μTBS values (p < 0.01), while only some specific such solutions improved the nanomechanical properties (p < 0.05) and preserved the structural morphology of the interface after aging. Pretreatment of acid-etched dentine using specific flavonoid-containing solutions may be a promising approach to improve both the nanomechanical properties and the durability of modern universal adhesive systems.