Pyung-chae Lim

Mr. Pyung-chae Lim


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 May 2020 in Remote Sensing
Verified
Journal Article
Open access
PDF file
JSJungil Shin
Jungil Shin
YCYeonmin Cho
Yeonmin Cho
PLPyung-chae Lim
Pyung-chae Lim
HLHae-Min Lee
Hae-Min Lee
Hoyong AhnHoyong Ahn
Hoyong Ahn
Taejung KimTaejung Kim
Taejung Kim
As the use of unmanned aerial vehicle (UAV) images rapidly increases so does the need for precise radiometric calibration. For UAV images, relative radiometric calibration is required in addition to the traditional vicarious radiometric calibration due to the small field of view. For relative radiometric calibration, some UAVs install irradiance sensors, but most do not. For UAVs without them, an intelligent scheme for relative radiometric calibration must be applied. In this study, a relative radiometric calibration method is proposed to improve the quality of a reflectance map without irradiance measurements. The proposed method, termed relative calibration by the optimal path (RCOP), uses tie points acquired during geometric calibration to define the optimal paths. A calibrated image from RCOP was compared to validation data calibrated with irradiance measurements. As a result, the RCOP method produces seamless mosaicked images with uniform brightness and reflectance patterns. Therefore, the proposed method can be used as a precise relative radiometric calibration method for UAV images.

28 May 2021 in Remote Sensing
Verified
Journal Article
Open access
PDF file
PLPyung-chae Lim
Pyung-chae Lim
SRSooahm Rhee
Sooahm Rhee
SJSeo Junghoon
Seo Junghoon
JKJae-In Kim
Jae-In Kim
JCJunhwa Chi
Junhwa Chi
Taejung KimTaejung Kim
Taejung Kim
Recently, the mapping industry has been focusing on the possibility of large-scale mapping from unmanned aerial vehicles (UAVs) owing to advantages such as easy operation and cost reduction. In order to produce large-scale maps from UAV images, it is important to obtain precise orientation parameters as well as analyzing the sharpness of they themselves measured through image analysis. For this, various techniques have been developed and are included in most of the commercial UAV image processing software. For mapping, it is equally important to select images that can cover a region of interest (ROI) with the fewest possible images. Otherwise, to map the ROI, one may have to handle too many images, and commercial software does not provide information needed to select images, nor does it explicitly explain how to select images for mapping. For these reasons, stereo mapping of UAV images in particular is time consuming and costly. In order to solve these problems, this study proposes a method to select images intelligently. We can select a minimum number of image pairs to cover the ROI with the fewest possible images. We can also select optimal image pairs to cover the ROI with the most accurate stereo pairs. We group images by strips and generate the initial image pairs. We then apply an intelligent scheme to iteratively select optimal image pairs from the start to the end of an image strip. According to the results of the experiment, the number of images selected is greatly reduced by applying the proposed optimal image–composition algorithm. The selected image pairs produce a dense 3D point cloud over the ROI without any holes. For stereoscopic plotting, the selected image pairs were map the ROI successfully on a digital photogrammetric workstation (DPW) and a digital map covering the ROI is generated. The proposed method should contribute to time and cost reductions in UAV mapping.