The elastic strain of lead-free relaxor K0.5Na0.5NbO3–SrTiO3 ceramic system, induced by applied electric fields with amplitudes up to 40kV∕cm, has been investigated. The strain response, being similarly low (order of 10−5) as in the classical lead magnesium niobate relaxor, is shown to be of solely electrostrictive origin, as a pure quadratic relation holds between induced strain and electric polarization. The strain dependence on the SrTiO3 content is presented and discussed. Furthermore, electrostrictive coefficients are shown to be constant over a broad temperature range and, similar to dielectric properties, independent of electric-field cycles, which suggests possible applications of this translucent, high-dielectric constant, and environmental-friendly ceramic system.
29 November 2019 in Physica Status Solidi (RRL) – Rapid Research Letters
For HfO2‐based films, which are mainly prepared by atomic layer deposition, the desired ferroelectric (FE) properties typically vanish while extending the thickness beyond a limit of about 50 nm. Herein, the successful fabrication of a 1 μm‐thick piezoelectric La:HfO2 film is demonstrated using chemical solution deposition, paving the way toward sensor and actuator applications. After identifying the optimal La content, the film thickness is increased from 45 nm to 1 μm. Polarization and strain measurements evidence the persistence of the FE properties at all thicknesses and even a slight improvement due to a better orientation of the polar axis at higher thicknesses. Scanning electron microscopy and X‐ray reflectivity reveal a fine‐grained microstructure and a density of only 80% of the theoretical value, which seems to be a common issue of solution‐deposited HfO2‐based films, based on the performed literature survey. Using tilt‐angle‐dependent X‐ray diffraction scans, homogeneous nucleation is found to be the likely root cause of the observed microstructure. It is suggested that this microstructure issue is key for the optimization of cycling stability of solution‐based films to exploit the full potential of the HfO2 for cost‐efficient, thick piezoelectric films.
The dielectric response of copper-phthalocyanine (CuPc) oligomers embedded in a poly(vinylidene fluoride-trifluoroethylene-chlorofluoroethylene) terpolymer matrix was studied. Although admixture of CuPc strongly increases the dielectric constant of the terpolymer at all temperatures, each of the two constituents determines the dielectric dynamics in a different temperature region—the relaxorlike matrix above and CuPc below the terpolymer’s freezing temperature. Two relaxations, reflecting the charge carriers’ response in CuPc, were detected. Results on ac conductivity reveal that the tunneling of polarons is the dominating charge transport mechanism.
In this research, the influences of the addition of PVP to PVDF-HFP polymers and the preparation of thin films using a solvent casting method were studied. The PVDF-HFP and polymer blend PVDF-HFP/PVP thin films with a nanostructured surface were investigated using scanning electron microscopy, differential scanning calorimetry, nanoindentation, and dielectric spectroscopy. The results showed that the PVP formed a dispersed phase (the poorer conductive islands) in the PVDF-HFP polymer matrix, which reduced its mechanical properties. The crystallinity of PVDF-HFP polymer decreased with the addition of PVP by 7.4%, but the PVP induced the formation of the polar β-phase of PVDF-HFP. Therefore, an improved dielectric response is expected, but it was not significantly improved even though the polar β-phase was detected. The contrasting effect was attributed to less conductive PVP islands on the surface of the PVDF-HFP/PVP polymer blend, which decreased its conductivity.
Various contributions are distinguished in the experimentally detected dielectric response of organic semiconductor copper phthalocyanine. While a giant dielectric constant of virgin samples is shown to be due to extrinsic effects, the temperature dependence of the intrinsic dielectric constant, being of the order of 10, indicates two structural phase transitions, as well as a dielectric relaxation reflecting the charge carriers’ response. Ac-conductivity data reveal not only the universal dielectric response arising from the polaron tunneling process, but also that another mechanism, which results in the superlinear power law increase in a frequency dependent conductivity, governs the charge transport at lower temperatures.
The dynamic processes in electron-irradiated poly(vinylidene fluoride-trifluoroethylene) [P(VDF-TrFE)], copolymer with a VDF content of 55 mol % have been studied by measurements of the temperature and frequency-dependent linear and third-order nonlinear dielectric constants. Analysis of the complex linear dielectric response by a temperature-frequency plot has revealed that the longest relaxation time diverges at while the bulk of the relaxation times remains finite below this freezing temperature. Such an asymmetric behavior is, together with the temperature dependence of the static field-cooled dielectric constant, very similar to that observed in classical relaxor systems, such as lead magnesium niobate and lanthanum lead zirconate titanate, and is reminiscent of the dynamic behavior observed in various spin glasses. In addition, a paraelectric-to-glass crossover in the temperature dependence of the dielectric nonlinearity typical for relaxors, has been observed.
About Me
Professor, physics of materials, J. Stefan Institute, Ljubljana, Slovenia; https://www.ijs.si/~bobnar/
Professor, physics of materials, J. Stefan Institute, Ljubljana, Slovenia; https://www.ijs.si/~bobnar/