This paper examines critical load and corresponding displacement of double cantilever beam (DCB) composite specimens made of glass/epoxy of three different layups. Experiments were conducted on these laminates, and the fracture energy,, was evaluated considering the root rotation at the crack tip. The present model requires the applied load-displacement history and crack extension to estimate fracture energy. Reduction schemes based on cubic and power law are also proposed to determine Young’s modulus and energy release rate and found good agreement with the published and test results.
Characterization of resistance to delamination is of great importance in selection of composite material. Mixed mode delamination is one of the most serious failure modes in aerospace composites. This article examines the delamination behaviour of mixed mode bending (MMB) test specimens made of glass/epoxy and carbon/epoxy composites. Literature published test data on different composites have been utilzed to identify the best suited failure criterion. Benzeggagh-Kenane (B-K) criterion as well as the polynomial criteria are used to generate failure envelopes from the fracture toughness data of composite specimens. Experiments were conducted on unidirectional fiber reinforced epoxy MMB specimens to analyze the failure trend of laminated composites and to validate the proposed polynomial criteria. Present investigations reveal that both B-K and polynomial criteria fit well for unidirectional specimens and cubic polynomial criterion fits well for angle-ply specimens.
Large deviations have been observed while analysing composite double cantilever beam (DCB) specimens assuming each cracked half as a simple cantilever beam. This paper examines the effect of rotational spring stiffnesson the critical fracture energyconsidering nonzero slope at the crack-tip of the DCB specimen by modelling each cracked half as the spring-hinged cantilever beam. The critical load estimates of DCB specimens fromare found to be in good agreement with in-house and existing test results of different composite material systems.