MXenes are a family of two-dimensional (2D) composite materials based on transition metal carbides, nitrides and carbonitrides that have been attracting attention since 2011. Combination of electrical and mechanical properties with hydrophilicity makes them promising materials for biomedical applications. This review briefly discusses methods for the synthesis of MXenes, their potential applications in medicine, ranging from sensors and antibacterial agents to targeted drug delivery, cancer photo/chemotherapy, tissue engineering, bioimaging, and environmental applications such as sensors and adsorbents. We focus on in vitro and in vivo toxicity and possible mechanisms. We discuss the toxicity analogies of MXenes and other 2D materials such as graphene, mentioning the greater biocompatibility of MXenes. We identify existing barriers that hinder the formation of objective knowledge about the toxicity of MXenes. The most important of these barriers are the differences in the methods of synthesis of MXenes, their composition and structure, including the level of oxidation, the number of layers and flake size; functionalization, test concentrations, duration of exposure, and individual characteristics of biological test objects Finally, we discuss key areas for further research that need to involve new methods of nanotoxicology, including predictive computational methods. Such studies will bring closer the prospect of widespread industrial production and safe use of MXene-based products.

Suspensions of Cu nanoparticles are promising for creating the new class of alternative antimicrobial products. In this study we examined copper nanoparticles of various sizes obtained by the method of wire electric explosion: nanopowder average size 50 nm (Cu 50) and 100 nm (Cu 100). The paper presents the complex study of the influence of physicochemical properties such as particle size and concentration of the freshly prepared and 24-hour suspensions of Cu nanoparticles in distilled water and physiological solution upon their toxicity to bacteriaE. coliM-17. Ionic solution of Cu²⁺and sodium dichloroisocyanurate was used for comparison study. It has been shown that decrease in the nanoparticle size leads to changes in the correlation between toxicity and concentration as toxicity peaks are observed at low concentrations (0.0001⋯0.01 mg/L). It has been observed that antibacterial properties of Cu 50 nanoparticle suspensions are ceased after 24-hour storage, while for Cu 100 suspensions no correlation between antibacterial properties and storage time has been noted. Cu 100 nanoparticle suspensions at 10 mg/L concentration display higher toxicity at substituting physiological solution for water than Cu 50 suspensions. Dependence of the toxicity on the mean particle aggregates size in suspension was not revealed.

Graphene nanoribbons are a type of graphene characterized by remarkable electrical and mechanical properties. This review considers the prospects for the application of graphene ribbons in biomedicine, taking into account safety aspects. According to the analysis of the recent studies, the topical areas of using graphene nanoribbons include mechanical, chemical, photo- and acoustic sensors, devices for the direct sequencing of biological macromolecules, including DNA, gene and drug delivery vehicles, and tissue engineering. There is evidence of good biocompatibility of graphene nanoribbons with human cell lines, but a number of researchers have revealed toxic effects, including cytotoxicity and genotoxicity. Moreover, the damaging effects of nanoribbons are often higher than those of chemical analogs, for instance, graphene oxide nanoplates. The possible mechanism of toxicity is the ability of graphene nanoribbons to damage the cell membrane mechanically, stimulate reactive oxidative stress (ROS) production, autophagy, and inhibition of proliferation, as well as apoptosis induction, DNA fragmentation, and the formation of chromosomal aberrations. At the same time, the biodegradability of graphene nanoribbons under the environmental factors has been proven. In general, this review allows us to conclude that graphene nanoribbons, as components of high-precision nanodevices and therapeutic agents, have significant potential for biomedical applications; however, additional studies of their safety are needed. Particular emphasis should be placed on the lack of information about the effect of graphene nanoribbons on the organism as a whole obtained from in vivo experiments, as well as about their ecological toxicity, accumulation, migration, and destruction within ecosystems.

Recently, metal oxide nanoparticles (NPs) have attracted attention as promising components for the protection and stimulation of plant microclones in tissue culture in vitro. However, the effect of NPs on the genetic mechanisms underlying plant adaptive responses remains poorly understood. We studied the effect of column-shaped CuO NPs 50 nm in diameter and 70–100 nm in length at a concentration of 0.1–10 mg/L on the development of phytopathogenic fungi Alternaria alternata, Fusarium oxysporum, and Fusarium avenaceum in culture, as well as on the infection of downy birch micro-clones with phytopathogens and the level of genes expression associated with the formation of plant responses to stress induced by microorganisms. CuO NPs effectively suppressed the development of colonies of phytopathogenic fungi A. alternata and F. avenaceum (up to 68.42% inhibition at 10 mg/L CuO NPs) but not the development of a colony of F. oxysporum. Exposure to the NPs caused multidirectional responses at the level of plant genes transcription: 5 mg/L CuO NPs significantly increased the expression level of the LEA8 and MYB46 genes and decreased the expression of DREB2 and PAL. Infection with A. alternata significantly increased the level of MYB46, LEA8, PAL, PR-1, and PR-10 transcripts in birch micro-clones; however, upon exposure to a medium with NPs and simultaneous exposure to a phytopathogen, the expression of the MYB46, PR-1, and PR-10 genes decreased by 5.4 times, which is associated with a decrease in the pathogenic load caused by the effect of NPs and the simultaneous stimulation of clones in vitro. The results obtained can be used in the development of preparations based on copper oxide NPs for disinfection and stimulation of plant phytoimmunity during clonal micropropagation of tree crops.

Recent studies have shown that nanomaterials, including carbon nanotubes, are associated with a wide range of effects on living organisms, from stimulation to toxic effects. Plants are an important object of such research, which is associated with the potential use of carbon nanomaterials in agriculture and environmental protection. At the same time, the specific mechanisms of formation of plant resistance to the effects of carbon nanotubes remain not fully understood, especially in woody plants. Therefore, we studied the effect of aqueous colloids of multi-walled carbon nanotubes (MWCNTs) with an outer diameter of 10–30 nm and a length of about 2 μm at a concentration of 1, 10, 50, and 100 mg/L on morphometric parameters and the level of expression of stress resistance genes in Betula pubescens Ehrh. and B. pendula Roth. plants in greenhouse conditions. The results showed an increase in the length and diameter of the shoot in the studied plants. The dry biomass of the leaf increased by 30%, the stem by 42%, and the root by 49% when using MWCNTs at a concentration of 10 mg/L. The expression of the stress resistance genes DREB2 and PR-10 significantly increased under the influence of 1 mg/L MWCNTs on plants of both species. At the same time, the use of 100 mg/L nanoparticles led to a decrease in the studied parameters in Betula pendula, which may be associated with the negative effect of MWCNTs in high concentrations. The revealed positive effects of low concentrations of MWCNTs on morphometric parameters and stimulation of stress resistance genes by nanotubes open up prospects for their use in woody plant biotechnology.

Toxicity of reduced graphene oxide (rGO) has been a topic of multiple studies and was shown to depend on a variety of characteristics of rGO and biological objects of interest. In this paper, we demonstrate that when studying the same dispersions of rGO and fluorescent Escherichia coli (E. coli) bacteria, the outcome of nanotoxicity experiments also depends on the type of culture medium. We show that rGO inhibits the growth of bacteria in a nutrition medium but shows little effect on the behavior of E. coli in a physiological saline solution. The observed effects of rGO on E. coli in different media could be at least partially rationalized through the adsorption of bacteria and nutrients on the dispersed rGO sheets, which is likely mediated via hydrogen bonding. We also found that the interaction between rGO and E. coli is medium-dependent, and in physiological saline solutions they form stable flocculate structures that were not observed in nutrition media. Furthermore, the aggregation of rGO and E. coli in saline media was observed regardless of whether the bacteria were alive or dead. Filtration of the aggregate suspensions led to nearly complete removal of bacteria from filtered liquids, which highlights the potential of rGO for the filtration and separation of biological contaminants, regardless of whether they include live or dead microorganisms.