One of the most important properties of hydrophobically functionalized polyelectrolytes (HF-PEs) and their assemblies is their ability to encapsulate hydrophobic/amphiphilic agents and provide release on demand of the entrapped payload. The aim of the present work was to synthesize and study self-organization behavior in aqueous solution of hydrophobically functionalized poly(acrylic acid) (PAA) comprising the ester-type pH labile moiety with various degrees of hydrophobization and side-chain lengths in the absence and presence of appropriate mono- and polyvalent electrolytes (i.e., NaCl or CaCl₂). The synthesis and purification of hydrophobically functionalized PAA were performed under mild conditions in order to avoid chemical degradation of the polymers. The modified polyelectrolytes self-assembly in aqueous systems was monitored using diffusion-ordered nuclear magnetic resonance (DOSY NMR). The performed studies, supported by the all-atoms molecular dynamics simulations, revealed a strong dependence of polyelectrolyte self-assembled state on concentration—specific concentration regions with the coexistence of both smaller and larger aggregates were observed (values of hydrodynamic diameter D_H around one nanometer and between two to six nanometers, respectively). Our investigations enabled us to gain crucial information about the self-assembly of the hydrophobically functionalized poly(acrylic acid) and opened the possibility of understanding and predicting its performance under various conditions.

This study presents a novel mixed-mode weak cation-exchange (WCX) material. This material was prepared by means of the functionalization of a mesoporous divinylbenzene (DVB) resin with maleic acid (maleic acid-DVB), which yielded a high carboxylic moiety content resulting in WCX interactions as well as suitable specific surface area for reversed-phase interactions. After the optimization of the solid-phase extraction (SPE) protocol to enhance the selectivity of the sorbent, this material was evaluated as a novel WCX sorbent in the SPE of a group of drugs from environmental water samples. The method is based on SPE followed by liquid chromatography (LC) coupled to high resolution mass spectrometry (HRMS) with an Orbitrap analyzer, and was validated and applied for the determination of basic drugs in river, effluent and influent wastewater samples. Maleic acid-DVB sorbent yielded suitable recovery rates (57% to 89%) and an acceptable matrix effect (<32%) thanks to the effective washing step included when these environmental waters were loaded through the novel resin. The method was applied to different environmental water samples and some basic drugs were suitably quantified in these environmental samples.

2,2′-thiobisethanol dimethacrylate/ethylene glycol dimethacrylate copolymer (coP-TEDMA/EGDMA) was used as a sorbent for gold recovery from residual solutions resulting from the electroplating industry. Firstly, synthesized material was characterized by X-ray diffraction, scanning electron microscopy, energy dispersive X-ray spectroscopy, and confocal laser scanning microscopy. The sorption process mechanism was evidenced on the basis of kinetic, thermodynamic and equilibrium studies. To highlight this, the influence of solution pH, temperature and gold initial concentration on maximum sorption capacity was studied. The obtained experimental data were modeled using Langmuir, Freundlich and Sips sorption isotherms, and it was observed that the Sips one was better for describing the studied sorption process. Kinetic data were fitted using pseudo-first-order and pseudo-second-order kinetic models. Of these models, the studied process was better described by the pseudo-second-order model. The thermodynamic parameters free Gibbs energy (ΔG0), enthalpy (ΔH0), and entropy (ΔS0) were evaluated on the basis of the van’t Hoff equation. On the basis of the thermodynamic study, it was concluded that gold recovery on coP-TEDMA/EGDMA is a spontaneous and endothermic process.

This research concerns the investigation of the preparation of polymeric nanocarriers containing a flavonoid—naringenin, xanthohumol or isoxanthohumol—based on Pluronics by the thin-film formation method. The size of the formed micelles and their stability upon dilution were evaluated using Dynamic light scattering (DLS) analysis; the high values of the drug loading and the encapsulation efficiency confirmed that the proposed systems of flavonoids delivery consisting of Pluronic P123 and F127 nanomicelles could effectively distribute the drug into tumour tissues, which makes these nanocarriers ideal candidates for passive targeting of cancer cells by the enhanced permeation and retention (EPR) effect. The in vitro cytotoxicity of proposed flavonoids in the Pluronic formulations was investigated by the SRB assay with human colon cancer cells. We designed mixed polymeric micelles, which was a successful drug delivery system for the case of naringenin not being able to enhance the bioavailability and cytotoxic activity of xanthohumol and isoxanthohumol. Furthermore, it was observed that the higher amount of polymer in the formulation achieved better cytotoxic activity.

This work investigates the sorption properties of poly(divinylbenzene) modified in the Diels–Alder reaction towards persistent and mobile metabolites of terbuthylazine. The batch experiments were carried out to examine the efficiency of desethyl-terbuthylazine and 2-hydroxy-terbuthylazine adsorption on the specific adsorbent and the impact of different factors on the adsorption process. Results fit well to a pseudo-second order kinetic model. It was confirmed that hydrogen bonds play an important role in the studied systems. Five times greater sorption of 2-hydroxy-terbuthylazine than desethyl-terbuthylazine was observed. The molecular structures of both metabolites exhibit complementarity to the arrangement of functional groups in the polymer but the differences in the physicochemical properties of the desethyl derivative make it a highly mobile compound with higher affinity to the aqueous phase. The equilibrium data in the batch study fit the Freundlich isotherm for 2-hydroxy-terbuthylazine, and for desethyl-terbuthylazine the Temkin and Dubinin–Radushkevich models were better. The adsorption capacities obtained under dynamic conditions were comparable with batch results. For column adsorption modeling the Bohart–Adams, Wolborska, Thomas and Yoon–Nelson models were used. The proposed microspheres can be reused easily with no significant decrease in adsorption capacity by using ethanol as eluent in the desorption.