Alberto Álvarez-Herrero

Dr. Alberto Álvarez-Herrero

Optical Technologies Development Area, Space Optics Department, Instituto Nacional de Técnica Aeroespacial (INTA), 28850 Torrejón de Ardoz – Madrid, Spain
orcid

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 November 2010 in Solar Physics
Verified
Journal Article
Open access
PDF file
VPV. Martínez Pillet
V. Martínez Pillet
JIJ. C. del Toro Iniesta
J. C. del Toro Iniesta
AÁAlberto Álvarez-Herrero
Alberto Álvarez-Herrero
VDV. Domingo
V. Domingo
JBJ. A. Bonet
J. A. Bonet
SDS. Vargas Domínguez
S. Vargas Domínguez
The Imaging Magnetograph eXperiment (IMaX) is a spectropolarimeter built by four institutions in Spain that flew on board the Sunrise balloon-borne solar observatory in June 2009 for almost six days over the Arctic Circle. As a polarimeter, IMaX uses fast polarization modulation (based on the use of two liquid crystal retarders), real-time image accumulation, and dual-beam polarimetry to reach polarization sensitivities of 0.1%. As a spectrograph, the instrument uses a LiNbO3 etalon in double pass and a narrow band pre-filter to achieve a spectral resolution of 85 mÅ. IMaX uses the high-Zeeman-sensitive line of Fe i at 5250.2 Å and observes all four Stokes parameters at various points inside the spectral line. This allows vector magnetograms, Dopplergrams, and intensity frames to be produced that, after reconstruction, reach spatial resolutions in the 0.15 – 0.18 arcsec range over a 50×50 arcsec field of view. Time cadences vary between 10 and 33 s, although the shortest one only includes longitudinal polarimetry. The spectral line is sampled in various ways depending on the applied observing mode, from just two points inside the line to 11 of them. All observing modes include one extra wavelength point in the nearby continuum. Gauss equivalent sensitivities are 4 G for longitudinal fields and 80 G for transverse fields per wavelength sample. The line-of-sight velocities are estimated with statistical errors of the order of 5 – 40 m s−1. The design, calibration, and integration phases of the instrument, together with the implemented data reduction scheme, are described in some detail.

24 November 2010 in Solar Physics
Verified
Journal Article
Open access
PDF file
PBP. Barthol
P. Barthol
AGA. Gandorfer
A. Gandorfer
SSS. K. Solanki
S. K. Solanki
MSM. Schüssler
M. Schüssler
BCB. Chares
B. Chares
ESE. Schmidt
E. Schmidt
The first science flight of the balloon-borne Sunrise telescope took place in June 2009 from ESRANGE (near Kiruna/Sweden) to Somerset Island in northern Canada. We describe the scientific aims and mission concept of the project and give an overview and a description of the various hardware components: the 1-m main telescope with its postfocus science instruments (the UV filter imager SuFI and the imaging vector magnetograph IMaX) and support instruments (image stabilizing and light distribution system ISLiD and correlating wavefront sensor CWS), the optomechanical support structure and the instrument mounting concept, the gondola structure and the power, pointing, and telemetry systems, and the general electronics architecture. We also explain the optimization of the structural and thermal design of the complete payload. The preparations for the science flight are described, including AIV and ground calibration of the instruments. The course of events during the science flight is outlined, up to the recovery activities. Finally, the in-flight performance of the instrumentation is discussed.

1 March 2017 in The Astrophysical Journal Supplement Series
Verified
Journal Article
Closed access
PDF file
SSS. K. Solanki
S. K. Solanki
TRT. L. Riethmüller
T. L. Riethmüller
PBP. Barthol
P. Barthol
SDS. Danilovic
S. Danilovic
WDW. Deutsch
W. Deutsch
ALA. Lecinski
A. Lecinski
The Sunrise balloon-borne solar observatory, consisting of a 1 m aperture telescope that provides a stabilized image to a UV filter imager and an imaging vector polarimeter, carried out its second science flight in 2013 June. It provided observations of parts of active regions at high spatial resolution, including the first high-resolution images in the Mg ii k line. The obtained data are of very high quality, with the best UV images reaching the diffraction limit of the telescope at 3000 Å after Multi-Frame Blind Deconvolution reconstruction accounting for phase-diversity information. Here a brief update is given of the instruments and the data reduction techniques, which includes an inversion of the polarimetric data. Mainly those aspects that evolved compared with the first flight are described. A tabular overview of the observations is given. In addition, an example time series of a part of the emerging active region NOAA AR 11768 observed relatively close to disk center is described and discussed in some detail. The observations cover the pores in the trailing polarity of the active region, as well as the polarity inversion line where flux emergence was ongoing and a small flare-like brightening occurred in the course of the time series. The pores are found to contain magnetic field strengths ranging up to 2500 G, and while large pores are clearly darker and cooler than the quiet Sun in all layers of the photosphere, the temperature and brightness of small pores approach or even exceed those of the quiet Sun in the upper photosphere.

8 December 2010 in Solar Physics
Verified
Journal Article
Open access
PDF file
TBT. Berkefeld
T. Berkefeld
WSW. Schmidt
W. Schmidt
DSD. Soltau
D. Soltau
ABA. Bell
A. Bell
HDH. P. Doerr
H. P. Doerr
ATA. M. Title
A. M. Title
This paper describes the wave-front correction system developed for the Sunrise balloon telescope, and it provides information about its in-flight performance. For the correction of low-order aberrations, a Correlating Wave-Front Sensor (CWS) was used. It consisted of a six-element Shack – Hartmann wave-front sensor (WFS), a fast tip-tilt mirror for the compensation of image motion, and an active telescope secondary mirror for focus correction. The CWS delivered a stabilized image with a precision of 0.04 arcsec (rms), whenever the coarse pointing was better than ± 45 arcsec peak-to-peak. The automatic focus adjustment maintained a focus stability of 0.01 waves in the focal plane of the CWS. During the 5.5 day flight, good image quality and stability were achieved during 33 hours, containing 45 sequences, which lasted between 10 and 45 min.

20 May 2020 in Experimental Astronomy
Verified
Journal Article
Open access
PDF file
SFS. Fineschi
S. Fineschi
GNGiampiero Naletto
Giampiero Naletto
MRM. Romoli
M. Romoli
VDVania Da Deppo
Vania Da Deppo
EAE. Antonucci
E. Antonucci
MCM. Castronuovo
M. Castronuovo
This paper describes the innovative optical design of the Metis coronagraph for the Solar Orbiter ESA-NASA mission. Metis is a multi-wavelength, externally occulted telescope for the imaging of the solar corona in both the visible and ultraviolet wavelength ranges. Metis adopts a novel occultation scheme for the solar disk, that we named “inverse external occulter”, for reducing the extremely high thermal load on the instrument at the spacecraft perihelion. The core of the Metis optical design is an aplanatic Gregorian telescope common to both the visible and ultraviolet channels. A suitable dichroic beam-splitter, optimized for transmitting a narrow-band in the ultraviolet (121.6 nm, HI Lyman-α) and reflecting a broadband in the visible (580–640 nm) spectral range, is used to separate the two optical paths. Along the visible light optical path, a liquid crystal electro-optical modulator, used for the first time in space, allows making polarimetric measurements.

1 December 2009 in IEEE Journal on Selected Areas in Communications
Verified
Journal Article
Closed access
IAI. Arruego
I. Arruego
HGH. Guerrero
H. Guerrero
SRS. Rodriguez
S. Rodriguez
JMJ. Martinez-Oter
J. Martinez-Oter
JJJ. J. Jimenez
J. J. Jimenez
JTJ. Torres
J. Torres
The application of Optical Wireless Links to intra- Spacecraft communications (OWLS) is presented here. This work summarizes ten years of developments, ranging from basic optoelectronic parts and front-end electronics, to different inorbit demonstrations. Several wireless applications were carried out in representative environments at ground level, and on in-flight experiments. A completely wireless satellite will be launched at the beginning of 2010. The benefits of replacing standard data wires and connectors with wireless systems are: mass reduction, flexibility, and simplification of the Assembly, Integration and Tests phases (AIT). However, the Aerospace and Defense fields need high reliability solutions. The use of COTS (Commercial-Off-The- Shelf) parts in these fields require extensive analyses in order to attain full product assurance. The current commercial optical wireless technology needs a deep transformation in order to be fully applicable in the aforementioned fields. Finally, major breakthroughs for the implementation of optical wireless links in Space will not be possible until dedicated circuits such as mixed analog/digital ASICs are developed. Once these products become available, it will also be possible to extend optical wireless links to other applications, such as Unmanned Air and Underwater Vehicles (UAV and UUV). The steps taken by INTA to introduce Optical Wireless Links in the Space environment are presented in this paper.