Thermally sprayed carbide cermet coatings, particularly those based on tungsten carbide (WC) and chromium carbide (Cr3C2) and produced with the high velocity oxygen fuel (HVOF) process, are used in tribological applications as environmentally friendly alternatives to electroplated hard chrome coatings. These functional coatings are especially prevalent in the automotive industry, offering excellent wear resistance. However, their mechanical and tribological performances are highly dependent on factors such as feedstock powders, spray parameters, and service conditions. This review aims to gain deeper insights into the above elements. It also outlines emerging advancements in HVOF technology—including in situ powder mixing, laser treatment, artificial intelligence integration, and the use of novel materials such as rare earth elements or transition metals—which can further enhance coating performance and broaden their applications to sectors such as the aerospace and hydro-machinery industries. Finally, this literature review focuses on process optimization and sustainability, including environmental and health impacts, critical material use, and operational limitations. It uses a life cycle assessment (LCA) as a tool for evaluating ecological performance and addresses current challenges such as exposure risks, process control constraints, and the push toward safer, more sustainable alternatives to traditional WC and Cr3C2 cermet coatings.
3 May 2016 in The European Physical Journal Applied Physics
Cold spraying technique is a promising process fabricating high quality metallic coatings. This work concerns both numerical and experimental investigations of cold sprayed copper coating taking into account impact conditions including, particle velocities and temperature, gas pressure and material nature. The conducted numerical study is an examination of the deformation behavior of Cu particles sprayed onto steel substrate using Abaqus/explicit software, allowing a good understanding of the deposition characteristics of copper particles and the effect of particle velocity on the coating microstructure. The numerical results show that particle impact velocity has a significant effect on its morphology; Lagrangian method exhibits an excessive distortion of the elements in the case of high impact velocity and fine meshing size, whereas simulation of particle impact using arbitrary Lagrangian-Eulerian (ALE) method is close to the experimental observations.
1 September 2016 in Lecture Notes in Mechanical Engineering