The nonradiative lifetime and spontaneous emission quantum efficiency in molecular-beam epitaxy grown bulk GaAs is determined using injection level dependent photoluminescence (PL) measurements. These measurements were performed at temperatures of 300, 230, 100, and using a HeNe pump laser with powers ranging from . The quantum efficiency and lifetime is inferred from the power law relation linking pump power and integrated PL signal that is predicted by the rate equations. The nonradiative lifetime for bulk GaAs is determined to be , with an additional temperature dependent component attributed to the AlGaAs barriers that rapidly reduces the nonradiative lifetime at temperatures above . The peak quantum efficiency is at and at temperatures below .
The physical characteristics of the fundamental absorption edge of semi-insulating GaAs and unintentionally doped GaSb, InAs, and InSb are examined using spectroscopic ellipsometry. A five parameter model is developed to describe the key characteristics of the absorption edge. Among these parameters are the bandgap energy, the characteristic energy of the Urbach tail, and the absorption coefficient at the bandgap energy. The results indicate that the Coulomb interaction strongly influences the shape of the band edge with progressively less influence as the bandgap energy decreases. The energy dependence of the optical transition strength is observed to be nearly constant in narrow bandgap InSb.
Gallium is incorporated into the strain-balanced In(Ga)As/InAsSb superlattice system to achieve the same mid-wave infrared cutoff tunability as conventional Ga-free InAs/InAsSb type-II superlattices, but with an additional degree of design freedom to enable optimization of absorption and transport properties. Time-resolved photoluminescence measurements of InGaAs/InAsSb superlattice characterization- and doped device structures are reported from 77 to 300 K and compared to InAs/InAsSb. The low-injection photoluminescence decay yields the minority carrier lifetime, which is analyzed with a recombination rate model, enabling the determination of the temperature-dependent Shockley–Read–Hall, radiative, and Auger recombination lifetimes and extraction of defect energy levels and capture cross section defect concentration products. The Shockley–Read–Hall-limited lifetime of undoped InGaAs/InAsSb is marginally reduced from 2.3 to 1.4 μs due to the inclusion of Ga; however, given that Ga improves the vertical hole mobility by a factor of >10×, a diffusion-limited InGaAs/InAsSb superlattice nBn could expect a lower bound of 2.5× improvement in diffusion length with significant impact on photodetector quantum efficiency and radiation hardness. At temperatures below 120 K, the doped device structures are Shockley–Read–Hall limited at 0.5 μs, which shows promise for detector applications.
1 March 2012 in Journal of Materials Science: Materials in Electronics
Time-resolved photoluminescence measurements are reported for InAsSbBi alloys grown by molecular beam epitaxy with Bi mole fractions ranging from 0 to 0.8%, yielding minority carrier lifetimes on the order of hundreds of nanoseconds. The minority carrier lifetimes extracted from the time-resolved photoluminescence measurements are comparable to those of lattice-matched InAsSb grown at the same respective temperatures. Nomarski imaging shows that smooth, droplet-free surface morphologies are obtained in 1 μm thick InAsSbBi epilayers grown at temperatures between 360 and 380 °C. The alloy composition-dependent bandgap energies for the InAsSbBi samples are determined from temperature-dependent steady-state photoluminescence measurements and compared with the tetragonal distortion measured by x-ray diffraction to determine the Sb and Bi mole fractions of each sample. The minority carrier lifetime and the achievable extension of the InAsSb(Bi) cut-off wavelength are analyzed as functions of alloy composition and compared with the performance of InAsSb layers with similar growth parameters.