Thermography and thermal wave techniques can be combined to provide in a short-time low-frequency phase angle images where nonthermal features can be suppressed. The principle is optical thermal wave generation simultaneously on the whole sample surface and sequential monitoring of all pixels using both thermographic techniques and lock-in data analysis. Due to parallel stationary excitation one can use low modulation frequencies allowing for a depth range that is of relevance for applications.
We present a nondestructive testing method based on lock-in thermography with mechanical heat excitation. Stresses are generated in the sample by vibrating it with a mechanical shaker. The mechanical energy is converted to thermal energy due to the acoustical damping. The defected regions have a stronger damping and also a stress concentration next to them, both of which result in a higher temperature generation. Because of the changes of the thermal properties, the defects also affect the heat conduction. These phenomena result in thermal anomalies due to the defects. The high-frequency vibration used for excitation is amplitude-modulated with a low frequency. The magnitude and phase of the sample temperature with respect to the modulation are measured with an infrared camera and a software lock-in technique. The use of phase information increases the reliability of the defect detection, and the application of high vibration frequencies results in a good thermal signal even at low stress levels, which helps to keep the test truly nondestructive. The suitability of the method was proved with samples of CFRP and aramid composites, and different polymers. The measurements included detection of impact damages, inclusions, voids, and cracks, and the evaluation of stress level distributions, paint thicknesses, and quality of bondings.
Conventional thermal wave imaging methods based on optical excitation are sensitive to all thermal boundaries and structures. However, if ultrasound is used for energy deposition, areas of enhanced mechanical loss angle are heated up selectively. As defects are usually correlated with an enhanced loss angle, ultrasound lockin thermography (ULT) is a defect-selective NDE method. Thermal wave emission from defects is monitored that are activated by absorption of ultrasound. In this paper we investigate the applicability of ULT for maintenance and inspection. Examples are presented showing the detection of defects in thick composite materials, of vertical cracks in several materials, and of hidden corrosion. Limitations given by the use of ultrasound are also discussed.