Single stage expansion devices are currently studied for small scale size power plant, often in combination with Organic Rankine Cycles for the employment of solar, geothermal, biomass or waste heat energies. A volumetric rotary single-stage expander was chosen in this study as expansion device for such type of plants. Its main characteristics and performances are discussed as a function of both the working conditions (fluid type, inlet temperature) and the working parameters (rotating speed, admission and recompression grades, valves advance). These analyses were carried out with numerical and experimental techniques. The analysis of the effects of the working condi- tions on the expander performances was carried out through a numerical model created with the simulation tool AMESim. At the same time, a prototype was built and experimented with compressed air to validate the model used by means of air mass flow rate, torque and indicated cycle. This way the isentropic and mechanical efficiency are discussed. The validation of the model was carried out by comparison with the experimental data collected at the engine test bench by operating the engine with compressed air. The indicated cycle, the air mass flow rate and the delivered torque were used as parameters of comparison. Moreover an experimental analysis at the fluid dynamic bench was carried out to validate the numerical 3D CFD model of the valves. The part load performances of this expansion device were studied by hypothesizing different control strategies and comparing them in terms of efficiency reduction respect to the design point. The influence of valves advance was also discussed
In the last decade many studies have been carried out on low temperature solar compound parabolic collectors (CPC) that are able to collect solar direct and diffuse radiation without the need of a tracking system, especially if coupled with small scale Organic Rankine Cycles for electricity and heat combined production. This paper presents a study on a thermal power plant that uses an expansion device driven with pressurized vapor generated with the heat collected by a CPC solar field. The numerical model of the expansion device was developed with the simulation tool AMESim v.12 and allowed the simulation of the indicated cycle of this machine for the evaluation of delivered power, isentropic efficiency and specific working fluid consumption. At the same time in this paper an analytical model of the evacuated solar CPC is presented for the evaluation of the collected heat as a function of sun incidence angle, external temperature, inlet carrier fluid temperature and mass flow rate. These two models were used in conjunction for the analysis of the electricity that may be generated as a function of the ambient and working conditions. This study was performed in steady state conditions and with several working fluids to evaluate the power that would be delivered by a given displacement expander rotating at a fixed speed. The results are given in terms of delivered power, thermal efficiency and amount of collecting surface needed for a given displacement expansion machine, calculated for several working fluids and different operating conditions