The existence, stability and collision dynamics of moving Bragg grating solitons in a semilinear dual-core system where one core has the Kerr nonlinearity and is equipped with a Bragg grating with dispersive reflectivity, and the other core is linear are investigated. It is found that moving soliton solutions exist as a continuous family of solutions in the upper and lower gaps of the system’s linear spectrum. The stability of the moving solitons are investigated by means of systematic numerical stability analysis, and the effect and interplay of various parameters on soliton stability are analyzed. We have also systematically investigated the characteristics of collisions of counter-propagating solitons. In-phase collisions can lead to a variety of outcomes such as passage of solitons through each other with increased, reduced or unchanged velocities, asymmetric separation of solitons, merger of solitons into a quiescent one, formation of three solitons (one quiescent and two moving ones) and destruction of both solitons. The outcome regions of in-phase collisions are identified in the plane of dispersive reflectivity versus frequency. The effects of coupling coefficient, relative group velocity in the linear core, soliton velocity and dispersive reflectivity and the initial phase difference on the outcomes of collisions are studied.

An improved design of a D-shaped photonic crystal fiber (PCF)-based refractive index (RI) sensor is proposed that uses the surface plasmon resonance phenomenon. The sensor consists of a large semicircular open channel that is inserted at the upside of the D-shaped PCF. A thin plasmonic sensing layer is deposited on the interior surface of the channel to excite the surface plasmon wave that eliminates the requirement of additional effort to fabricate a well-polished sensing layer of the D-shaped sensor. The sensor’s optical properties are numerically explored by the finite element method. The sensor is optimized to detect the RI of biological and biochemical analytes in the range of 1.33 to 1.44, shows spectral sensitivity as high as 63,000 nm/RIU with a spectral resolution of 1.59 × 10⁻⁰⁶ RIU, and maximum amplitude sensitivity of 1439 RIU⁻¹ with a resolution of 6.94 × 10⁻⁰⁶ RIU. It is also found that the sensor’s linearity parameter is very high with a large figure of merit of about 839. Additionally, the sensor’s fabrication tolerance is studied by varying its structural parameters. Therefore, high sensing parameters with a wide detection range make this microchannel-based D-shaped PCF sensor an appropriate device for the application of biological and biochemical analyte detection.

We consider the copropagation of three (pump, Stokes, and anti-Stokes) self-trapped beams that interact through the parametric four-photon-mixing process in a (1 + 1 dimension) uniform self-focusing nonlinear medium. The stationary propagation involving three trapped beams is shown to be possible below a critical frequency shift when the phase difference between the three waves is either matched or highly mismatched. Most importantly, the steady-state solutions are found to be stable, as in the case of presence of only one soliton beam, except that the two (in-phase) fundamental stationary states launched in parallel will not return to their original states periodically after collision; rather, they may repel each other on collision and propagate in symmetrically tilted directions thereafter with increasing separation.

We investigate return-to-zero (RZ) to non-return-to-zero (NRZ) format conversion by means of the linear time-invariant system theory. It is shown that the problem of converting random RZ stream to NRZ stream can be reduced to constructing an appropriate transfer function for the linear filter. This approach is then used to propose novel optimally-designed single fiber Bragg grating (FBG) filter scheme for RZ-OOK/DPSK/DQPSK to NRZ-OOK/DPSK/DQPSK format conversion. The spectral response of the FBG is designed according to the optical spectra of the algebraic difference between isolated NRZ and RZ pulses, and the filter order is optimized for the maximum Q-factor of the output NRZ signals. Experimental results as well as simulations show that such an optimally-designed FBG can successfully perform RZ-OOK/DPSK/DQPSK to NRZ-OOK/DPSK/DQPSK format conversion.