Wider band-gap window layers can enhance the transmission of sunlight in the short-wavelength region and improve the performance of CdTe solar cells. In this work, we investigated the band structure of In-doped Zn1−xMgxO (ZMO:In) by using first-principles calculations with the GGA + U method and simulated the performance of ZMO:In/CdTe devices using the SCAPS program. The calculation results show that with the increased Mg doping concentration, the band gap of ZMO increases. However, the band gap of ZMO was decreased after In incorporation due to the downwards shifted conduction band. Owing to the improved short circuit current and fill factor, the conversion efficiency of the ZMO:In-based solar cells show better performance as compared with the CdS-based ones. A highest efficiency of 19.63% could be achieved owing to the wider band gap of ZMO:In and the appropriate conduction band offset (CBO) of ~0.23 eV at ZMO:In/CdTe interface when the Mg concentration x approaches 0.0625. Further investigations on thickness suggest an appropriate thickness of ZMO:In (x = 0.0625) in order to obtain better device performance would be 70–100 nm. This work provides a theoretical guidance for designing and fabricating highly efficient CdTe solar cells.
Se alloying CdTe absorber has attracted much attention for enhancing the short current density (Jsc) of CdTe device with high fill factor (FF) and open circuit voltage (Voc). The structural, morphological, optical properties and electronic structure of co-sputtered CdTe1-xSex films ("0≤x≤1" ) are determined in this study. All CdTe1-xSex films are polycrystalline in nature. Phase transition occurs as x increases. The band gap (Eg) of CdTe1-xSex films can be tuned from 1.35 eV to 1.70 eV. CdTe and CdTe0.838Se0.162 films are p-type but the others are n-type, judging from the relative position of Fermi energy (EF) and the intrinsic Fermi energy (EI). Appropriate electric field can form in Se alloying CdTe absorber with a gradient composition, which enhances carrier collection. The barrier height at the emitter/absorber interface can be designed appropriately by changing the composition of CdTe1-xSex films. These results give reasons why CdTe1-xSex absorber is better than CdTe and device performance can be further improved by optimizing the composition distribution of CdTe1-xSex alloys.
7 November 2017 in Journal of Electronic Materials