The abatement of the pollutants deriving from diesel engines in the vehicle sector still represents an interesting scientific and technological challenge due to increasingly limiting regulations. Meeting the stringent limits of NOx and soot emissions requires a catalytic system with great complexity, size of units, and number of units, as well as increased fuel consumption. Thus, an after-treatment device for a diesel vehicle requires the use of an integrated catalyst technology for a reduction in the individual emissions of exhaust gas. The representative technologies devoted to the reduction of NOx under lean-burn operation conditions are selective catalytic reduction (SCR) and the lean NOx trap (LNT), while soot removal is mainly performed by filters (DPF). These devices are normally used in sequence, or a combination of them has been proposed to overcome the drawbacks of the individual devices. This review summarizes the current state of NOx and soot abatement strategies. The main focus of this review is on combined technologies for NOx removal (i.e., LNT–SCR) and for the simultaneous removal of NOx and soot, like SCR-on-Filter (SCRoF), in series LNT/DPF and SCR/DPF, and LNT/DPF and SCR/DPF hybrid systems.
Influence of the process parameters for the industrially relevant reaction of free fatty acid (FFA) with glycerol is investigated. Furthermore, several drying techniques are investigated and a novel method is suggested that can provide more realistic experimental conditions. Silica as an absorbent is found to be a more suitable method for water removal than distillation or carrier gas. Using response surface methodology, important parameters are identified and optimal conditions found. Empirical correlation is developed to account for the most important parameters. Both oil:glycerol ratio and temperature have optimal values for which the highest conversion can be achieved. Interestingly, the highest conversion can be obtained at 220°C; above this temperature the conversion decreases. It is found that the influence of oil:glycerol ratio also exhibits anomalous behavior, where conversion is constant and decreases above a certain value. At optimal conditions, the FFA is reduced to 1.6% from the initial 8.6%.
1 April 2018 in Chemical Engineering Research and Design
The use of La-based, Cu (LCO), Mn (LMO) and Fe (LFO) perovskites doped with Ag was studied for potential application as cGPF soot oxidation catalysts. Special emphasis was placed on the effect of the soot, reaction gas composition, changes in rich/lean conditions and the resulting physicochemical changes in the catalyst and their reversibility. The use of a catalyst reduced the soot oxidation temperature significantly in a low-O2 environment and with Ag doping the soot oxidation temperature was decreased by 170 °C in loose contact and 230 °C in tight contact compared to uncatalyzed oxidation. For the soot oxidation in an O2-free environment, the highest oxygen storage capacity was found for LCO and LCAO (1 mol O per molcat). The release of such a high amount of O and reduction of Cu2+ to Cu0 was accompanied by the loss of perovskite structure (LCO → Cu/La2O3), which could be reversed following exposure to a high temperature low-O2 environment.