The current study investigated and optimized key process parameters affecting mushroom hydrolysis with crude enzymatic extract. The crude enzyme was prepared by solid-state fermentation of pineapple peels using Aspergillus niger. The reaction parameters viz. time, temperature, pH and enzyme concentration were optimized using the central composite design of the response surface methodology. The model predicted glucose yield of 1.49 mg/mL at optimal pH of 6.5, temperature of 50 °C, enzyme loading of 5 % (v/v), and reaction time of 12 h. Mushroom hydrolysis at the same optimal model conditions, increased glucose yield by 10%. More so supplementing SSF media with 0.2% (w/v) Tween-80 and 0.08% (w/v) yeast extract at moisture level of 70–75% significantly (p value < 0.05) improved hydrolytic efficiency of the crude enzyme extract by 2.2-fold. This study provides baseline data that will be useful in developing a low-cost enzyme-based process for hydrolyzing mushrooms to recover high-value products.
23 July 2023 in European Journal of Sustainable Development Research
Conventional dehairing methods in the traditional leather-making processes, consume large amounts of toxic chemicals and produce a toxic sludge/effluent, posing disposal challenges and consequently environmental pollution. The by-products of leather processing such as hair and fat, contain toxic chemicals. In this study, crude alkaline protease from bacillus cereus strain 1-p, was used to dehair sheepskin with up to 99.00% recovery of valuable wool and fat. The optimum temperature and pH for wool removal were found to be 30 °C and 11, respectively. The recovered wool was enzymatically hydrolyzed to obtain wool hydrolysate powder (48.1% yield). FTIR spectra of the wool hydrolysate showed the presence of amide A, I, and II absorption bands. Further, the amino acid analysis, revealed the presence of 15 amino acids, with glutamic acid (19.65 mole %), glycine (12.72 mole %), and leucine (9.42 mole %) being the most abundant. Fat was trans-esterified using methanol, in the presence of tert-butanol, and the resultant fatty acid methyl esters characterization was done using gas chromatography/mass spectrometry (GC/MS) analysis. GC/MS analysis showed the presence of 60 methyl esters corresponding to 60 fatty acids. The most abundant fatty acid was 9-octadecenoic (oleic) acid (41.64%), followed by hexa-decanoic (palmitic) acid (22.50%), and tetra-decanoic (myristic) acid (4.21%). Thermo-gravimetric analysis of the wool hydrolysate showed that it had good thermal stability. It is shown that crude alkaline protease extracted from bacillus cereus strain 1-p can completely eliminate the use of toxic sodium sulfide and lime in dehairing of skins/hide in tanneries, eliminating environmental pollution. Furthermore, the recovery of fat and wool using an eco-friendly enzymatic dehairing process can significantly reduce the pollution load in the effluent. The recovered wool and fats can be applied in the production of wool hydrolysate, which is high in protein content, amino acids and biodiesel.
Generation of three dimensional structures of macromolecules using in silico structural modeling technologies such as homology and de novo modeling has improved dramatically and increased the speed by which tertiary structures of organisms can be generated. This is especially the case if a homologous crystal structure is already available. High-resolution structures can be rapidly created using only their sequence information as input, a process that has the potential to increase the speed of scientific discovery. In this study, homology modeling and structure prediction tools such as RNA123 and SWISS-MODEL were used to generate the 40S ribosomal subunit from Plasmodium falciparum. This structure was modeled using the published crystal structure from Tetrahymena thermophila, a homologous eukaryote. In the absence of the Plasmodium falciparum 40S ribosomal crystal structure, the model accurately depicts a global topology, secondary and tertiary connections, and gives an overall root mean square deviation (RMSD) value of 3.9 Å relative to the template׳s crystal structure. Deviations are somewhat larger in areas with no homology between the templates. These results demonstrate that this approach has the power to identify motifs of interest in RNA and identify potential drug targets for macromolecules whose crystal structures are unknown. The results also show the utility of RNA homology modeling software for structure determination and lay the groundwork for applying this approach to larger and more complex eukaryotic ribosomes and other RNA-protein complexes. Structures generated from this study can be used in in silico screening experiments and lead to the determination of structures for targets/hit complexes.
The development of novel anti-infectives against Kinetoplastids pathogens targeting proteins is a big problem occasioned by the antigenic variation in these parasites. This is also a global concern due to the zoonosis of these parasites, as they infect both humans and animals. Therefore, we need not only to create novel antibiotics, but also to speed up the development pipeline for these antibiotics. This may be achieved by using novel drug targets for Kinetoplastids drug discovery. In this study, we focused our attention on motifs of rRNA molecules that have been created using homology modeling. The RNA is the most ambiguous biopolymer in the kinetoplatid, which carries many different functions. For instance, tRNAs, rRNAs, and mRNAs are essential for gene expression both in the pro-and eukaryotes. However, all these types of RNAs have sequences with unique 3D structures that are specific for kinetoplastids only and can be used to shut down essential biochemical processes in kinetoplastids only. All these features make RNA very potent targets for antibacterial drug development. Here, we combine in silico methods combined with both computational biology and structure prediction tools to address our hypothesis. In this study, we outline a systematic approach for identifying kinetoplastid rRNA-ligand interactions and, more specifically, techniques that can be used to identify small molecules that target particular RNA. The high-resolution optimized model structures of these kineoplastids were generated using RNA 123, where all the stereochemical conflicts were solved and energies minimized to attain the best biological qualities. The high-resolution optimized model’s structures of these kinetoplastids were generated using RNA 123 where all the stereochemical conflicts were solved and energies minimized to attain the best biological qualities. These models were further analyzed to give their docking assessment reliability. Docking strategies, virtual screening, and fishing approaches successfully recognized novel and myriad macromolecular targets for the myxobacterial natural products with high binding affinities to exploit the unmet therapeutic needs. We demonstrate a sensible exploitation of virtual screening strategies to 18S rRNA using natural products interfaced with classical maximization of their efficacy in phamacognosy strategies that are well established. Integration of these virtual screening strategies in natural products chemistry and biochemistry research will spur the development of potential interventions to these tropical neglected diseases.