This article deals with the issue of online chatter detection during milling. The aim is to achieve a verification of the reliability and robustness of selected methods for the detection of chatter that can be evaluated on the machine tool in real time by using the accelerometer signal. In the introductory part of the paper, an overview of the current state of the art in the field of chatter detection is summarized. Entropic methods have been selected that evaluate the presence of chatter from the qualitative behavior of the signal rather than from the magnitude of its amplitude, because the latter can be affected by the transmission of vibrations to the accelerometer position. Another criterion for selection was the potential for practical implementation in a real-time evaluation of the accelerometer signal, which is nowadays quite commonly installed on machine tools. The robustness of the methods was tested with respect to tool compliance, which affects both chatter occurrence and vibration transfer to the accelerometer location. Therefore, the study was carried out on a slender milling tool with two different overhangs and on a rigid roughing tool. The reference stability assessment for each measurement was based on samples of the machined surface. The signals obtained from the accelerometer were then post-processed and used to calculate the chatter indicators. In this way, it was possible to compare different methods in terms of their ability to achieve reliable in-process detection of chatter and in terms of the computational complexity of the indicator.

Control systems of modern machine tools are equipped with a number of functions for volumetric accuracy enhancement. These functions can compensate for all the geometric errors of the axes, which are characterized by 21 errors for a 3-axis machine tool. Compensation data are stored in compensation tables and the control system calculates actual compensation based on these tables and actual machine tool position. Geometric errors are measured within the machine tool maintenance plan and it presents a time-consuming process. Measurement is mainly based on interferometric devices, where the precise setup of laser source and detector is challenging. This article introduces an original system for automatic interferometer set up to speed up the measurement of geometric errors. The system is designed for the interferometer Renishaw XM-60, which simultaneously measures all 6 degrees of freedom. The developed control software identifies interferometer position and transforms the measured data into a machine coordinate system. Numerical simulation verified the proposed solution.

Machine tool rams are important constructional elements found on vertical lathes as well as on many other machines. In most cases, a machine tool ram constitutes an assembly with significant dynamic compliance that affects the machine’s ability to achieve stable cutting conditions. There are various solutions for increasing a machine tool ram’s stiffness and damping. This paper describes an innovative concept of a two-axial electromagnetic actuator for controlled vibration dampers with high dynamic force values. The described solution is purposefully based on the use of standard electric drives. As a result, the size of the actuator is easier to scale to the required application. The solution is designed as a spacer between the end of the ram and the head. The paper presents the actuator concept, construction design, current control loop solution and experimental verification of the controlled vibration damper’s function on the test ram in detail. The presented position measurement concept will enable the use of non-contact position sensors for motor commutation as well as for possible use in vibration suppression control. Applications can be expected mainly in the field of vibration suppression of vertical rams of large machine tools.