Ivan Ivanov

Ivan Ivanov


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 November 2021 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
IIIvan Ivanov
Ivan Ivanov
ABAlexander M. Baranov
Alexander M. Baranov
VTVladislav A. Talipov
Vladislav A. Talipov
SMSergei M. Mironov
Sergei M. Mironov
SASaba Akbari
Saba Akbari
KNKirill S. Napolskii
Kirill S. Napolskii

1 August 2019 in Sensors and Actuators B: Chemical
Verified
Journal Article
Closed access
IIIvan Ivanov
Ivan Ivanov
ABAlexander M. Baranov
Alexander M. Baranov
SASaba Akbari
Saba Akbari
SMSergey Mironov
Sergey Mironov
EKElena Karpova
Elena Karpova

19 April 2022 in IEEE Sensors Letters
Verified
Journal Article
Closed access
IIIvan Ivanov
Ivan Ivanov
ABAlexander Baranov
Alexander Baranov
SMSergey Mironov
Sergey Mironov
SASaba Akbari
Saba Akbari
The research demonstrates for the first time the high selectivity of catalytic hydrogen sensors to other hydrocarbons (methane, propane, hexane, butane, ethane, and ethylene) at a temperature less than 70 °С. Two circuits were used to measure the response of the sensors: a Wheatstone bridge circuit and a divider circuit. Hydrogen measurement was conducted within a temperature range of 66–130 °С. The sensors exhibited high sensitivity (25–35 mV/%) and low power consumption (approximately 8.6 mW). The Wheatstone bridge circuit was observed to have the maximum value of selectivity and sensitivity.

12 March 2025 in Sensors and Actuators A: Physical
Verified
Journal Article
Closed access
TOTatiana Osipova
Tatiana Osipova
ABAlexander Baranov
Alexander Baranov
HZHaowen Zhang
Haowen Zhang
IIIvan Ivanov
Ivan Ivanov
YJYangyang Ju
Yangyang Ju

13 November 2023 in IEEE Sensors Letters
Verified
Journal Article
Closed access
VTVladislav Talipov
Vladislav Talipov
ABAlexander Baranov
Alexander Baranov
IIIvan Ivanov
Ivan Ivanov
YJYangyang Ju
Yangyang Ju
The purpose of this work is to prove that the reaction of hydrogen combustion in a catalytic sensor can occur at room temperature. This study was designed to examine the response of catalytic hydrogen sensors to heating voltage (S-characteristics) as the ambient temperature is changed from 17 ºС to -48 ºС. A platinum group catalyst based on Pt and Pd composite with molar ratio Pt:Pd = 1:3 was used as a catalyst. It was shown that the sensor starts responding to hydrogen upon zero heating voltage at 17 ºС. When the ambient temperature decreases, an initial section appears on the dependences of the sensor response to hydrogen. This section contains no response and expands rightwards to the area of higher heating voltages from 0 to 442 mV as the ambient temperature decreases from 17 ºС to -48 ºС. This research identified the threshold temperature at which catalytic hydrogen combustion starts in a sensor with a Pt+3Pd composite catalyst. This temperature was found to fall in the range of 17-22 ºС.

28 February 2022 in NAUCHNOE PRIBOROSTROENIE
Verified
Journal Article
Closed access
TOT. V. Osipova
T. V. Osipova
ABA. M. Baranov
A. M. Baranov
IIIvan Ivanov
Ivan Ivanov
In this article the study of the possibility and evaluation of the use of the principal component analisys as an alternative algorithm for processing data of thermocatalytic sensors is carried out. Based on the obtained results it was found that the effect of the sensor's operating temperature on the response is minimal, which makes it possible to combine them into a single system. At the same time the different concentration of the supplied gas is uniquely determined. The research methodology is defined and the results are presented, showing that the principal component analysis makes it possible to distinguish sensor responses at different concentrations without using additional mathematical operations to prepare the obtained data.