Combining hardness indentation tests and micro-Raman spectroscopy it is shown that metallic Si-II is produced near the interface of a diamond indenter and silicon to a depth of about 0.5 μm, where the highest stresses (hydrostatic and deviatoric) exist. At fast unloading rates Si-II transforms to the amorphous state, whereas a mixture of the r8 high pressure polymorph Si-XII and the bc8 phase Si-III forms upon a slow load release. The region of Si-III+Si-XII is surrounded by the wurtzite structured Si-IV, where the stresses during the indentation had not been high enough to cause the transition to the metallic state. Thus, because of shear deformation a direct transformation to Si-IV takes place. Outside the phase-transformed regions the classical aspects of indentation-induced deformation by dislocation glide, twinning and crack formation are observed. Annealing of the high pressure phases leads to the formation of Si-IV at moderate temperatures and to the reversal to the original diamond structure (Si-I) at temperatures above 500 °C. Using the laser beam of the Raman spectrometer to anneal the samples the phase transitions could be monitored directly. The formation of silicon polymorphs other than amorphous or metallic structures during hardness indentation is, to the best of our knowledge, reported here for the first time. The results compare well with the polymorphism in Si that is known from diamond anvil cell experiments.
13 February 2008 in Critical Reviews in Solid State and Materials Sciences
Silicon carbide (SiC) as both the most important non-oxide ceramic and promising semiconductor material grows stoichiometric SiO2 as its native oxide. During passive oxidation, a surface transformation of SiC into silica takes place causing bulk volume and bulk mass increase. This review summarizes state-of-the-art information about the structural aspects of silicon carbide, silica, and SiC–SiO2 interfaces and discusses physicochemical properties and kinetics of the processes involved. A special section describes the electronic properties of carbide–oxide interfaces, which are inferior compared to Si–SiO2 interfaces, limiting the use of SiC-based electronics. In the oxidation of SiC there is a variety of parameters (e.g., porosity, presence of sintering aids, impurities, crystallographic orientation, surface treatment, and atmospheric composition) influencing the process. Therefore, the kinetics can be complex and will be discussed in detail. Nonetheless, a general linear-parabolic time-law can be found for most SiC materials for passive oxidation, thus indicating a mainly diffusion-controlled mechanism. The pronounced anisotropy of SiC expresses itself by quite different oxidation rates for the various crystallographic faces. Manifold impact factors are reflected by oxidation rate-constants for silicon carbide that vary over orders of magnitude. The understanding of SiC oxidation and silica formation is still limited; therefore, different oxidation models are presented and evaluated in the light of current knowledge.
Experiments were carried out on primitive natural lherzolitic compositions from 10 to 60 kb and to 1400°C. Mineral compositions were reversed by using mixes of finely ground (<20μm) minerals from natural rock samples with different initial compositions. The minerals were mixed in proportions to give a primitive upper mantle composition. Further starting materials were a synthetic mineral mix and a sintered oxide mix. Equilibrium was thus approached from different chemical directions, and equilibrium mineral compositions were inferred from the overlap of microprobe analyses. Fe-loss problems were avoided by using single-crystal olivines as sample containers. Samples were placed into holes drilled into cylindrically shaped olivine crystals, which in turn were welded into Pt capsules. A further advantage of this method is that oxygen fugacities seem to be buffered by the Ni precipitation curve. This curve lies very close to the iron-wüstite (IW) buffer curve for mantle olivines. Oxygen fugacities calculated from compositions of experimentally produced spinels give values slightly above the IW buffer curve. Therefore, practically no Fe3+ should be present in our experimental charges.
1 January 2007 in Journal of the European Ceramic Society