The structure and vibrational predissociation dynamics of HeCl2 are studied by pump–probe spectroscopy and by three‐dimensional quantum mechanical calculations. Parity selected excitation spectroscopy is used to confirm the essential features of the previous analysis of the HeCl2B←X laser excited fluorescence spectra. Product vibrational and rotational state distributions are measured for the v’=6, 8, 12, 20, and 24 levels of HeCl2 in the B state. For the v’=6 and 8 levels the dependence of the product state distribution on the initially excited rotational state is also measured. Although the dissociation dynamics are dominated by Δv=−1, V→T energy transfer, several interesting effects are revealed by monitoring the product rotational degrees of freedom. Due to the symmetry of the HeCl2 potential, the parity of the initially excited HeCl2 rotational state is conserved during the dissociation dynamics. Even when a single initial rotational state is excited, the observed product rotational state distribution is bimodal. The product rotational distribution is nearly independent of the amount of kinetic energy released to the product degrees of freedom. Three‐dimensional quantum mechanical calculations using a simple potential energy surface are remarkably successful at reproducing the details of the experimental measurements. Only five parameters of the potential were adjusted to calculate the excitation spectrum, the vibrational predissociation product state distributions, and the lifetimes of the excited states. Analysis of the dissociation mechanism in terms of simple models, however, is not straightforward. In particular, the impulsive, quasiclassical half‐collision model is not compatible with the observed independence of the product rotational state distribution from the amount of kinetic energy which is released. The close agreement between state‐to‐state experiment and quantum theory on the HeCl2 dynamics shows that the shortcomings of more approximate theories are fundamental and cannot be attributed to lack of knowledge of the true potential energy surface.
Three‐dimensional quantum mechanical calculations for vibrational predissociation of the Ne⋅⋅⋅Cl2 van der Waals complex are presented and compared with experiments. Lifetimes and final rotational state distributions were obtained for the two processes: (i) Ne⋅⋅⋅Cl2(X,v=1) →Ne+Cl2(X,v=0) and (ii) Ne⋅⋅⋅Cl2(B,v=11) →Ne +Cl2(B,v=10,9) where v denotes the vibrational quantum number of Cl2 and X and B specify electronic states of Ne⋅⋅⋅Cl2 which correlate with the X1∑+0g and B3∏+0u states of the free Cl2 molecule, respectively. The van der Waals interaction potential was taken to have the same form in the X and B states. At short distances, it is described by a sum of Morse pairwise potentials between the Ne atom and each of the Cl atoms, and between the neon atom and the center of mass of Cl2. At large distances the potential switches to an anisotropic van der Waals interaction with R−6 and R−8 dependence. The parameters were adjusted so that the T‐shaped configuration the potential matched the one determined from scattering experiments. The initial quasibound state wave function of the complex was calculated variationally, while the final continuum wave functions were obtained by integration of the rotational close coupled Schrödinger equations. Finally, the lifetime and the final rotational state distribution were calculated using the Fermi golden rule. A line shape calculation verified the validity of the golden rule approximation for this system. The lifetimes obtained for the X and the B states differ by several orders of magnitude, the X state being the longest lived as observed experimentally. The calculated lifetimes and rotational distributions of the Cl2 fragments agree qualitatively with the experimental values. The rotational distribution is compared to that obtained from a decomposition of the initial quasibound state in terms of free rotor states.
Product state distributions are reported for the vibrational predissociation of the NeCl2, B state, v’=6 through v’=13 levels. For the lower vibrational levels, Δv=−1 dissociation produces a bimodal Cl2 product rotational state distribution with the first maximum at j=4 and a secondary maximum at j=20. Surprisingly, the positions of these maxima are the same for v’=6, 7, 8, 9, and 10. For higher vibrational levels the limited available phase space constricts the observed rotational distribution allowing the Ne–Cl2 bond energy D0 to be determined. D0 is 54±2 cm−1 for the B electronic state, and 60±2 cm−1 for the ground electronic state. Δv=−2 dissociation produces a rotational distribution which, although not bimodal, is otherwise quite similar to that of the Δv=−1 channel, even though significantly more energy is released to product translation for Δv=−2. This behavior is quite different from what would be predicted by an impulsive half‐collision model for the dynamics. Three dimensional quantum calculations on a simple atom–atom potential energy surface were able to reproduce most of the essential features of the experimental results. We conclude that the anisotropy of the initial wave function and that of the coupling between the covalent and van der Waals modes is more important in determining the product rotational distribution than is the kinematics of the dissociation trajectory. Since the rotational distribution produced by the Δv=−2 channel is similar to that of the Δv=−1 channel, the Δv=−2 dynamics probably occurs by a direct coupling between the quasibound state and the continuum rather than by a sequential mechanism with two Δv=−1 steps.
The structure, dissociationdynamics, and intermolecular potential energy surfaces of the He79Br2 van der Waals molecule have been studied using high resolution, two color, pump–probe laser induced fluorescencespectroscopy and three dimensional quantum mechanical calculations. A conical nozzle produces higher centerline cluster densities than a standard nozzle, and allows data collection further downstream from the nozzle. This yields improved signal to noise ratios and lower Doppler widths. He79Br2 is found to have a T‐shaped average geometry with He to Br2 center‐of‐mass distances of 3.98 Å and 4.11 Å for the X and B states, respectively, somewhat longer than previously reported. Spectra were also obtained for excitation to excited bending levels of the van der Waals coordinate. However, these spectra have yet to be rotationally assigned. Vibrational predissociation line widths for the B state of He79Br2 have been measured for three new vibrational levels and range from 0.036 cm−1 for B, v′=8 to 0.062 cm−1 for B, v′=12. These values are somewhat larger than was expected based on previous HeBr2 linewidth measurements for higher vibrational levels. Forms for the potential energy surface that have previously been used to simulate the spectra of HeCl2 have been applied to the HeBr2 data. For the HeBr2 X state, two potentials are tested. First, a slightly anisotropic, one center Morse–Spline–van der Waals potential with angle dependent parameters is used. Second a much more anisotropic potential obtained from ab initio calculations is tested. The more anisotropic potential produces a significantly better fit to the data. The B state potential is constructed using Morse atom–atom potentials for the short range part of the He–Br interaction. This simple potential is sufficient to fit the main excitation band, but does not yield a fit to spectra involving vibrationally excited van der Waals modes.
Two forms for the HeCl2 potential are compared to the available experimental data. First, an atom–atom form that incorporates the recently measured anisotropic He–Cl potential is used. The anisotropy of this potential is slight, and its strengths and weaknesses are similar to previous potentials in which the He–Cl interaction was treated as isotropic. In particular, the fit to the scattering data is poor. Second, a fit to abinitio points calculated using Mo/ller–Plesset perturbation theory to fourth order was performed. The resulting potential is much more anisotropic than any potential previously proposed and tested for HeCl2. This potential fits the rotationally resolved excitation spectra as well as do previous empirical potentials, and is consistent with certain features of the total differential scattering data with which previous potentials were not. Although the abinitio potential has a global minimum in the linear configuration, the probability distribution of the ground vibrational level still maximizes in the perpendicular configuration, accounting for the good fit to the rotationally resolved spectrum. We conclude that noble gas–halogen potentials are much more anisotropic than previously believed, and we suggest several experiments that could help to confirm this anisotropy.
High quality ab initio calculations for the interaction of He with the state of for three distances, and for the interaction are used to obtain a three-dimensional potential energy surface for the system. The surface was used to calculate excitation spectra, predissociation lifetimes, and product state distributions for comparison with experimental data, and yields a remarkably good agreement. The largest discrepancy is in the dependence of the lifetime on the excited state vibrational level. The calculated lifetimes are too short for the lowest measured vibrational levels. To investigate how the surface could be modified to obtain even better agreement, a microgenetic algorithm was used to adjust the potential parameters to improve the fit. The adjusted surface has a softer repulsive wall for small Cl–Cl separations which helps to lengthen the excited state lifetimes and yields better agreement with the data. Also, the shape of the well region is adjusted somewhat in the fitting process, which yields a stronger dependence of lifetime on vibrational level.