The traditional hydrophobic solarevaporator is generally obtained through the modification of alkyl or fluoroalkyl on the photothermal membrane. However, the modified groups can easily be oxidized in the long-term use process, resulting in the poor salt resistance and stability of photothermal membrane. In order to solve this problem, a simple polypyrrole/polyvinylidene fluoride membrane, consisting of an intrinsic hydrophobic support (polyvinylidene fluoride) and a photothermal material (polypyrrole), was fabricated by ultrasonically mixing and immersed precipitation. This photothermal membrane showed good self-floating ability in the process of water evaporation. In order to further improve the photothermal conversion efficiency, a micropyramid structure with antireflective ability was formed on the surface of membrane by template method. The micropyramids can enhance the absorption efficiency of incident light. The water evaporation rate reached 1.42 kg m−2 h−1 under 1 sun irradiation, and the photothermal conversion efficiency was 88.7%. The hydrophobic polyvinylidene fluoride ensures that NaCl cannot enter into membrane during the evaporation process of the brine, thus realizing the stability and salt resistance of polypyrrole/polyvinylidene fluoride in 3.5%wt and 10%wt NaCl solution.
For the solar water evaporation system, there are no reports on the self-healing support, which is crucial for the sustainable use of solar evaporation membrane. In this work, a self-healing hydrogel is prepared via free radical copolymerization with covalent cross-linking and coordination cross-linking and is used as a photothermal water evaporation support. The photothermal material is then introduced into the hydrogel by physically doping acetylene carbon black. At the same time, inverted micro-pyramids are fabricated on the surface of the hydrogel by soft imprint to increase the utilization efficiency of incident light. The water evaporation rate of the composite membrane can reach 1.58 kg m−2 h−1, and the breaking elongation is 1580%. It can self-heal after it is completely broken, and can still be stretched 3 times its original length. The design of this self-healing photothermal membrane will provide a new idea for its application in a harsh outdoor environment.
1 February 2016 in Russian Journal of General Chemistry
A non-high vacuum technique was used to fabricate a TiO2 protective layer of a Si-based photocathode, in which MOF derivatives enhance carrier transfer efficiency. The photocathode has high onset potential, high photocurrent and long-term stability.
This paper reports a novel method to fabricate a bio-inspired SERS substrate with low reflectivity, ultra-sensitivity, excellent uniformity, and recyclability. First, double layers of polystyrene spheres with different particle sizes were assembled on the surface of a silicon wafer to act as a moth-like template. Second, through the template sacrifice method, the TiO2 film with a three-dimensional moth-like eye structure was induced by the double-layer polystyrene spheres in the previous step, and its microscopic morphology showed a high degree of order. Finally, Ag nanoparticles were assembled on the TiO2 film to form a bio-inspired SERS substrate. This ordered bio-inspired structure can not only reduce reflection, but also reinforce the uniformity of hotspot density, which helps to improve the sensitivity and uniformity of the Raman signal. This bio-inspired SERS substrate can detect R6G molecules at a concentration as low as 1.0 × 10−10 mol/L, and its enhancement factor (EF) can reach 6.56 × 106. In addition, the composite of Ag and TiO2 can realize the photocatalytic degradation of R6G and then realize the recyclability of the SERS substrate.