Loess is a kind of special soil with structure and hydrocollapse behavior; due to the particularity of loess, the deformation regularity of the tunnel in loess shows different characteristics from those in rock. To ensure the safety of construction, crown settlement (CS) and horizontal convergence (HC) are widely used to assess the stability of the tunnel structural system. Based on statistical analysis, this study focused on analyzing the influence of cover depth on the deformation of surrounding rock of loess tunnels by ANOVA, and relationships between them were presented by regression analysis. The achieved results indicated that the influence of cover depth on deformation was not obvious in shallow tunnels, while the cover depth had a significant effect on deformation in deep tunnels. Based on the difference of influence of cover depth on deformation between shallow tunnels and deep tunnels, a method for determining the cover depth threshold (CDT) in the tunnel by statistical analysis was proposed. The horizontal and vertical deformations in shallow tunnels were discrete and obeyed the positive distribution, mainly concentrated within 200 mm. The deformation allowance in shallow tunnels was recommended to be 200 mm. In deep tunnels, as the cover depth increased, the deformation increased linearly, while the CS/HC decreased.
1 January 2018 in Advances in Materials Science and Engineering
The aim of the study was to solve the problem of drainage stability of pavement base in cold and Cloudburst area. With porous concrete as the research object, an optimum design of porous concrete was determined using a step filling and orthogonal test method, and the relationship between the porosity and the connected porosity of the porous concrete was analyzed. Furthermore, drainage performance and frost resistance of the pavement, compressive strength of the porous concrete, bending strength, and compressive elastic modulus were studied. The results show that the effects of water‐cement ratio on the strength of porous concrete based on the step filling method are the most significant. In addition, the connected porosity and goal porosity have a good linear relationship; that is, the drainage performance increases with the increase in connected porosity, whereas the frost resistance, compressive strength, flexural tensile strength, and compressive elastic modulus decrease with the increase in connected porosity. Based on an engineering project in Inner Mongolia (in China), it was shown that porous concrete with a goal porosity of 15% used as a pavement base could meet the requirements of cold weather, showers, and heavy traffic.
A method of load calculation in a tunnel was adopted in consideration of the state of covering depth. Due to the macropore characteristics of loess soil, the existing demarcation regulations of deep and shallow tunnels are inappropriate for large-section and shallow loess in highway tunnels. To determine the load of large-section loess tunnel and provide a proper reference for structural design, the theoretical basis for distinguishing depth of deep and shallow tunnels, as well as the characteristics of common calculation methods for surrounding rock load on depth, were analyzed. Through statistical analysis and significance analysis, the significance of the variation of surrounding rock pressure with cover depth was studied. Correlation analysis was carried out on significant results to fit the relationship between cover depth and surrounding rock pressure. The results showed that the surrounding rock pressure varied linearly with the cover depth, and the surrounding rock pressure was about 0.3 times the initial pressure in deep tunnels. The surrounding rock pressure of shallow tunnels did not change significantly with the cover depth, and the surrounding rock pressure was loose pressure. A method based on statistics was proposed to distinguish the cover depth threshold (CDT) of deep and shallow tunnels.
30 November 2017 in Geomatics, Natural Hazards and Risk
This Express Letter gives a brief report of the devastating floods in Yulin City, Northern Shaanxi, NW China, which occurred after colossal rainstorms on 26 July 2017. Here, we discuss the disaster and rescue measures, compare them to a set of 149 major rainstorms in Yulin City from 1971 to 2016, and then analyze the correlation coefficients between the rainstorms and the Circulation Characteristics Index. The results show annual increases in the economic losses caused by flood disasters. In addition, the Western Pacific Subtropical High and the Northeast Cold Air are related to precipitation and floods in Yulin City from July to August, so they are important keys to predict future flood disasters in the region.