Halide perovskites (HPs), renowned for their intriguing optoelectronic properties, such as robust light absorption coefficient, long charge transfer distance, and tunable band structure, have emerged as a focal point in the field of photocatalysis. However, the photocatalytic performance of HPs is still inhibited by rapid charge recombination, insufficient band potential energy, and limited number of surface active sites. To overcome these limitations, the integration of two-dimensional (2D) materials, characterized by shortened charge transfer pathways and expansive surface areas, into HP/2D heterostructures presents a promising avenue to achieve exceptional interfacial properties, including extensive light absorption, efficient charge separation and transfer, energetic redox capacity, and adjustable surface characteristics. Herein, a comprehensive review delving into fundamentals, interfacial engineering, and charge carrier dynamics of HP/2D material heterostructures is presented. Numerous HP/2D material photocatalysts fabricated through diverse strategies and interfacial architectures are systematically described and categorized. More importantly, the enhanced charge carrier dynamics and surface properties of the HP/2D material heterostructures are thoroughly investigated and discussed. Finally, an analysis of the challenges faced in the development of HP/2D photocatalysts, alongside insightful recommendations for potential strategies to overcome these barriers, is provided.
For clean hydrogen (H 2 ) production, electrocatalysis and photocatalysis are widely regarded as promising technologies to counter the increasing energy crisis.
The dopant (P and B) diffusion path in n- and p-types polycrystalline-Si gates of trench-type three-dimensional (3D) metal-oxide-semiconductor field-effect transistors (MOSFETs) were investigated using atom probe tomography, based on the annealing time dependence of the dopant distribution at 900 °C. Remarkable differences were observed between P and B diffusion behavior. In the initial stage of diffusion, P atoms diffuse into deeper regions from the implanted region along grain boundaries in the n-type polycrystalline-Si gate. With longer annealing times, segregation of P on the grain boundaries was observed; however, few P atoms were observed within the large grains or on the gate/gate oxide interface distant from grain boundaries. These results indicate that P atoms diffuse along grain boundaries much faster than through the bulk or along the gate/gate oxide interface. On the other hand, in the p-type polycrystalline-Si gate, segregation of B was observed only at the initial stage of diffusion. After further annealing, the B atoms became uniformly distributed, and no clear segregation of B was observed. Therefore, B atoms diffuse not only along the grain boundary but also through the bulk. Furthermore, B atoms diffused deeper than P atoms along the grain boundaries under the same annealing conditions. This information on the diffusion behavior of P and B is essential for optimizing annealing conditions in order to control the P and B distributions in the polycrystalline-Si gates of trench-type 3D MOSFETs.