Maria Ivanova

Ms. Maria Ivanova

Volga State University of Technology
orcid

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
12 May 2021 in Inorganics
Verified
Journal Article
Open access
PDF file
YAYamen Albadi
Yamen Albadi
MIMaria Ivanova
Maria Ivanova
LGLeonid Grunin
Leonid Grunin
KMKirill D Martinson
Kirill D Martinson
MCMaria I. Chebanenko
Maria I. Chebanenko
VPVadim Igorevich Popkov
Vadim Igorevich Popkov
Nanocrystals of gadolinium orthoferrite (GdFeO3) with morphology close to isometric and superparamagnetic behavior were successfully synthesized using direct, reverse and microreactor co-precipitation of gadolinium and iron(III) hydroxides with their subsequent heat treatment in the air. The obtained samples were investigated by PXRD, FTIR, low-temperature nitrogen adsorption-desorption measurements, HRTEM, SAED, DRS and vibration magnetometry. According to the X-ray diffraction patterns, the GdFeO3 nanocrystals obtained using direct co-precipitation have the smallest average size, while the GdFeO3 nanocrystals obtained using reverse and microreactor co-precipitation have approximately the same average size. It was shown that the characteristic particle size values are much larger than the corresponding values of the average crystallite size, which indicates the aggregation of the obtained GdFeO3 nanocrystals. The GdFeO3 nanocrystals obtained using direct co-precipitation aggregate more than the GdFeO3 nanocrystals obtained using reverse co-precipitation, which, in turn, tend to aggregate more strongly than the GdFeO3 nanocrystals obtained using microreactor co-precipitation. The bandgap of the obtained GdFeO3 nanocrystals decreases with decreasing crystallite size, which is apparently due to their aggregation. The colloidal solutions of the obtained GdFeO3 nanocrystals with different concentrations were investigated by 1H NMR to measure the T1 and T2 relaxation times. Based on the obtained r2/r1 ratios, the GdFeO3 nanocrystals obtained using microreactor, direct and reverse co-precipitation may be classified as T1, T2 and T1–T2 dual-modal MRI contrast agents, respectively.

15 December 2021 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
Marina GorbunovaMarina Gorbunova
Marina Gorbunova
EKEvgenii V. Komov
Evgenii V. Komov
LGLeonid Grunin
Leonid Grunin
MIMaria Ivanova
Maria Ivanova
AAAinur F. Abukaev
Ainur F. Abukaev
DADenis Anokhin
Denis Anokhin
The influence of the hard segment nature on the crystallization kinetics of multi-block thermoplastic polyurethanes containing poly(butylene adipate) (PBA) as a soft segment was investigated. Using a combination of FTIR spectroscopy, time-domain 1H nuclear magnetic resonance (TD-NMR), differential scanning calorimetry (DSC), fast-scanning calorimetry (FSC) and wide-angle X-ray diffraction (WAXS), it was shown that aliphatic, cycloaliphatic and aromatic diisocyanates affect the phase separation efficiency of soft and hard segments. The best phase separation efficiency was observed for a sample containing aliphatic diisocyanate due to the development of a hydrogen bond network. The thermal history, phase separation and the degree of ordering of the polyurethane determine the polymorphic behavior of melt-crystallized PBA. The formation of a partially-ordered mesophase of linear aliphatic polyurethane leads to an increase in the crystallization rate of PBA at room temperature and the formation of thermodynamically stable α-crystals. The presence of bulk cycloaliphatic and aromatic diol-urethane fragments prevents the phase separation of PBA, which crystallizes after slow cooling in a mixture of α- and β-crystalline forms. The new nanocalorimetry technique allows the identification of a direct correlation between the phase separation and crystallization kinetics of the melt-crystallized PBA in a wide range of cooling rates – from 2 to 30 000 K s−1. Particularly, ultra-fast cooling suppresses the nucleation of the β-phase of PBA resulting in slow crystallization of only α-modification at room temperature. The role of the polyurethane mesophase in the crystallization of the soft segment was discussed for the first time.

27 August 2023 in Applied Magnetic Resonance
Verified
Journal Article
Closed access
PDF file
LGLeonid Grunin
Leonid Grunin
MIMaria Ivanova
Maria Ivanova
VSVeronika Schiraya
Veronika Schiraya
TGTatiana Grunina
Tatiana Grunina

17 October 2025 in Food Analytical Methods
Verified
Journal Article
Closed access
PDF file
EIEsmanur Ilhan
Esmanur Ilhan
MIMaria Ivanova
Maria Ivanova
CFCristian A. Fuentes
Cristian A. Fuentes
HSHatice Gul Solmaz
Hatice Gul Solmaz
AGAylin Ozgur Goksu
Aylin Ozgur Goksu
MOMecit Halil Oztop
Mecit Halil Oztop

25 November 2022 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
YAYamen Albadi
Yamen Albadi
MIMaria Ivanova
Maria Ivanova
LGLeonid Grunin
Leonid Grunin
RMRodion A. Makarin
Rodion A. Makarin
AKAleksei S. Komlev
Aleksei S. Komlev
VPVadim I. Popkov
Vadim I. Popkov
The sample of GdFeO3 nanoparticles obtained by ultrasound-assisted co-precipitation synthesis may be classified as a T1-contrast agent for MRI at 0.47 and 1.5 T, as a T1–T2 dual-modal contrast agent at 3 T and as a T2-contrast agent at 4.7 T.

1 November 2019 in Biophysics
Verified
Journal Article
Closed access
PDF file
Yuriy B. GruninYuriy B. Grunin
Yuriy B. Grunin
MIMaria Ivanova
Maria Ivanova
DMD. S. Masas
D. S. Masas
LGL. Yu. Grunin
L. Yu. Grunin
Water sorption on cellulose was studied in detail. The mechanism of the adsorption–desoprtion hysteresis loop was considered using NMR relaxation methods and sorption phenomena. The degree of crystallinity was found to decrease in cellulose during water sorption, while the specific surface area of cellulose increased because a wedging pressure arose as a new adsorbent–adsorbate interface formed. The most significant changes in these parameters were observed during desorption and were accompanied by the formation of an additional capillary-porous system in cellulose. Correlations were observed between the surface tension coefficient at the solid–liquid interface, the adsorption equilibrium constant, and the net heat of adsorption.