The ISOLPHARM (ISOL technique for radioPHARMaceuticals) project is dedicated to the development of high purity radiopharmaceuticals exploiting the radionuclides producible with the future Selective Production of Exotic Species (SPES) Isotope Separation On-Line (ISOL) facility at the Legnaro National Laboratories of the Italian National Institute for Nuclear Physics (INFN-LNL). At SPES, a proton beam (up to 70 MeV) extracted from a cyclotron will directly impinge a primary target, where the produced isotopes are released thanks to the high working temperatures (2000 °C), ionized, extracted and accelerated, and finally, after mass separation, only the desired nuclei are collected on a secondary target, free from isotopic contaminants that decrease their specific activity. A case study for such project is the evaluation of the feasibility of the ISOL production of ⁶⁴Cu and ⁶⁷Cu using a zirconium germanide target, currently under development. The producible activities of ⁶⁴Cu and ⁶⁷Cu were calculated by means of the Monte Carlo code FLUKA, whereas dedicated off-line tests with stable beams were performed at LNL to evaluate the capability to ionize and recover isotopically pure copper.

Materials and components employed in the presence of intense neutron and gamma fields are expected to absorb high dose levels that may induce deep modifications of their physical and mechanical properties, possibly causing loss of their function. A protocol for irradiating elastomeric materials in reactor mixed neutron and gamma fields and for testing the evolution of their main mechanical and physical properties with absorbed dose has been developed. Four elastomeric compounds used for vacuum O-rings, one fluoroelastomer polymer (FPM) based and three ethylene propylene diene monomer rubber (EPDM) based, presently available on the market have been selected for the test. One EPDM is rated as radiation resistant in gamma fields, while the other elastomers are general purpose products. Particular care has been devoted to dosimetry calculations, since absorbed dose in neutron fields, unlike pure gamma fields, is strongly dependent on the material composition and, in particular, on the hydrogen content. The products have been tested up to about 2 MGy absorbed dose. The FPM based elastomer, in spite of its lower dose absorption in fast neutron fields, features the largest variations of properties, with a dramatic increase in stiffness and brittleness. Out of the three EPDM based compounds, one shows large and rapid changes in the main mechanical properties, whereas the other two feature more stable behaviors. The performance of the EPDM rated as radiation resistant in pure gamma fields does not appear significantly better than that of the standard product. The predictive capability of the accelerated irradiation tests performed as well as the applicable concepts of threshold of radiation damage is discussed in view of the use of the examined products in the selective production of exotic species facility, now under construction at the Legnaro National Laboratories of the Italian Istituto Nazionale di Fisica Nucleare. It results that a careful account of dose rate effects and oxygen penetration in the material, both during test irradiations and in operating conditions, is needed to obtain reliable predictions.