Macroscale finite element (FE) models, with their ability to simulate additive manufacturing (AM) processes of metal parts and accurately predict residual stress distribution, are potentially powerful design tools. However, these simulations require enormous computational cost, even for a small part only a few orders larger than the melt pool size. The existing adaptive meshing techniques to reduce computational cost substantially by selectively coarsening are not well suited for AM process simulations due to the continuous modification of model geometry as material is added to the system. To address this limitation, a new FE framework is developed. The new FE framework is based on introducing updated discretized geometries at regular intervals during the simulation process, allowing greater flexibility to control the degree of mesh coarsening than a technique based on element merging recently reported in the literature. The new framework is evaluated by simulating direct metal deposition (DMD) of a thin-walled rectangular and a thin-walled cylindrical part, and comparing the computational speed and predicted results with those predicted by simulations using the conventional framework. The comparison shows excellent agreement in the predicted stress and plastic strain fields, with substantial savings in the simulation time. The method is then validated by comparing the predicted residual elastic strain with that measured experimentally by neutron diffraction of the thin-walled rectangular part. Finally, the new framework's capability to substantially reduce the simulation time for large-scale AM parts is demonstrated by simulating a one-half foot thin-walled cylindrical part.

Purpose: Additive manufacturing (AM) processes involve a layer-by-layer sintering of metallic powders to produce fully functional three-dimensional parts. This layer-by-layer building process provides a unique opportunity to enhance mechanical properties by applying treatments that previously were possible only on the surface in traditional manufacturing techniques. The purpose of the study is to examine the effect of ultrasonic peening (UP) applied during a layer-by-layer direct metal laser sintering (DMLS) fabrication of 316L stainless steel on its mechanical properties and microstructure. Design/methodology/approach: Uniaxial tensile tests were performed at 1.27 mm/s to determine the effect of UP treatment on the average global behavior of a 316L part, whereas hardness measurements using nanoindentation were performed to determine the modification of local mechanical properties. Compressive buckling tests at a loading rate of 3 mm/min were performed on sample coupons with a large aspect ratio to evaluate the effect of UP on any potential delamination of DMLS layers. Techniques such as optical and scanning electron microscopy (SEM) imaging were utilized to determine the effect of UP on the microstructure. Findings: Overall, significant modification in mechanical properties such as hardness and yield strength, along with microstructure, was observed. Large increases in both the average global and local mechanical properties, as well as a disruption in the columnar grain microstructure, was observed in DMLS parts treated with UP treatment. Originality/value: Results indicate an opportunity for UP to be used as an in-situ process during AM processes for dynamically altering the mechanical behavior, microstructure, and distortion due to residual stress formation, in a tunable fashion.