The influence of La doping on the crystal structure and multiferroic properties of BiFeO3 (BFO) thin films was investigated. BFO-based films of pure perovskite phase were deposited on BaPbO3∕Pt∕TiOx∕SiO2∕Si substrates by rf-magnetron sputtering. The increased dielectric constant and remanent polarization of the La-doped BFO films were due to the increased lattice parameters and an improved crystallinity. The polarization switching and the fatigue behavior of the BFO films were significantly enhanced by the La doping. The in-plane magnetization-field curves revealed that the room-temperature saturated magnetization of the BFO films increased with La doping.
The strong coupling between antiferromagnetism and ferroelectricity at room temperature found in BiFeO3 generates high expectations for the design and development of technological devices with novel functionalities. However, the multi-domain nature of the material tends to nullify the properties of interest and complicates the thorough understanding of the mechanisms that are responsible for those properties. Here we report the realization of a BiFeO3 material in thin film form with single-domain behaviour in both its magnetism and ferroelectricity: the entire film shows its antiferromagnetic axis aligned along the crystallographic b axis and its ferroelectric polarization along the c axis. With this we are able to reveal that the canted ferromagnetic moment due to the Dzyaloshinskii–Moriya interaction is parallel to the a axis. Furthermore, by fabricating a Co/BiFeO3 heterostructure, we demonstrate that the ferromagnetic moment of the Co film does couple directly to the canted moment of BiFeO3.
Nonpolar resistive switching (RS), which is the coexistence of unipolar and bipolar RS characteristics, in the Pt/MgO/Pt memory device with the nonforming nature is demonstrated. The nonforming nature is ascribed to the relatively high defect density of the MgO film deposited by using the ion beam sputtering in Ar atmosphere. The results of Auger electron spectroscopy and x-ray photoelectron spectroscopy analyses combing with the temperature dependence of resistance suggest that metallic Mg filaments are formed in the low resistance state. The voltage-polarity-independent RESET process implies that filaments may be ruptured by local Joule heating, leading to nonpolar characteristics.
A highly ordered FePt phase was directly achieved by using 2 MeV He-ion irradiation without conventional postannealing. The coercivity greater than 5700 Oe can be obtained after disordered FePt was irradiated at the beam current of several with the ion doses of The high beam-current-density results in direct beam heating on samples. In addition, the irradiation-induced heating process provides efficient microscopic energy transfer and creates excess point defects, which significantly enhances the diffusion and promotes the formation of the ordered phase. Consequently, the direct ordering of FePt took place by using ion-irradiation heating at temperature as low as Due to the feasibilities of the fast temperature rise and the focused beam size, this ion-irradiation heating treatment can be potentially used as an alternative technique for the rapid thermal annealing and for the magnetic patterning.