Ground-level ozone, worldwide recognised amongst key pollutants responsible for smog and a significant pulmonary irritant is formed in troposphere via a photolytic process from nitrogen oxides (NOx). Volatile Organic Compounds (VOC) during their decomposition in the atmosphere interact with NOx and thus affect ozone formation. Their interactions are not equal and have been quantified in Maximum Incremental Reactivities (MIR). Using MIR, calculated was ozone formation potential of VOCs emitted from an aromatic solvent-containing paint that is used for marking of roads in Kraków, Poland. To simulate possible environmental benefits of using alternative materials, analysis was then extended to model paint without aromatic solvent and a waterborne paint.Ozone formation potential of the road marking paint currently used as standard in Kraków was calculated to be more than twice the amount of VOCs it emits: 240kg of solvents evaporating from one tonne of paint might cause formation of over 550kg of ozone – in Kraków that means up to 42 tonnes of tropospheric ozone annually. Elimination of the aromatic solvent would not lead to lesser VOC emissions, but decrease ozone production capability by about 50%. Further reductions could be realised with waterborne paint – VOC emissions lowered by 79% and potentially formed ozone reduced by up to 93%.A cradle-to-grave Life Cycle Assessment (LCA) performed on the three analysed paints demonstrated that durability is the main environmental impact factor. Assuming service life achieved at our test field, where modern waterborne paints applied at 600μm wet film and reflectorised with properly selected high-performance glass beads complied with the specification for two years, they definitely are more sustainable choices as compared to solventborne materials.Quantification of the effect of produced ozone on health was beyond the scope of this work, but based on literature reports a measureable effect is anticipated due to a well-documented correlation between increased tropospheric ozone level and increased mortality and morbidity
5 May 2023 in Transportation Research Part D: Transport and Environment
Introduction: On majority of roads, horizontal road markings are essential safety feature that must be periodically renewed to maintain appropriate performance. Results: The use of a premium road marking system resulted in prolonged the service life as compared to a standard system, which would be financially-neutral in the long term despite much higher unit and initial costs; advantageously, 54% less glass beads and 63% less paint would be required over 10-year life cycle. When these products usage savings are recalculated into raw materials consumption, the premium system would demand about 21% more of titanium dioxide, but that would be offset by approximately 25% reduction in the consumption of acrylic resin and circa 97% reduction in organic solvents usage and emissions. Conclusions: The results from this analysis can be used by road administrators to select the best systems, by policy makers seeking minimisation of environmental impacts, and by contractors who won performance tenders.
Road markings must be reflectorised with glass beads to be visible to drivers at night, retro-reflecting light from vehicle’s headlights, which is critical for road safety. Four commonly used types of glass beads were evaluated in a laboratory setting for retroreflectivity and their surfaces were analysed using optical and scanning electron microscopy. The glass beads were subjected to abrasion and a visual correlation was sought between the measured retroreflectivity and the surface damage. Scratching the glass bead surface with corundum in a rotary drum resulted in major differences in the rates of damage development, depending on the type of the glass beads, and it could be correlated with the rate of retroreflectivity decay. The relative results from abrasion testing were confirmed under tyre action during a turntable evaluation. Based on the outcomes of these tests, service lives, defined as maintaining appropriately high retroreflectivity, were predicted and used to calculate the consumption of raw materials—the basic sustainability parameter. It was shown that the use of ‘premium’ glass beads, enhanced with TiO2 and made in a proprietary process, provided the road marking system characterised by the lowest long-term consumption of resources.