Free-electron lasers (FELs) operate at wavelengths from millimeter waves through hard x-rays. At x-ray wavelengths, FELs typically rely on self-amplified spontaneous emission (SASE). Typical SASE emission contains multiple temporal ‘spikes’ which limit the longitudinal coherence of the optical output; hence, alternate schemes that improve on the longitudinal coherence of the SASE emission are of interest. In this paper, we consider electron bunches that are shorter than the SASE spike separation. In such cases, the spontaneously generated radiation consists of a single optical pulse with better longitudinal coherence than is found in typical SASE FELs. To investigate this regime, we use two FEL simulation codes. One (MINERVA) uses the slowly-varying envelope approximation (SVEA) which breaks down for extremely short pulses. The second (PUFFIN) is a particle-in-cell simulation code that is considered to be a more complete model of the underlying physics and which is able to simulate very short pulses. We first anchor these codes by showing that there is substantial agreement between the codes in simulation of the SPARC SASE FEL experiment at ENEA Frascati. We then compare the two codes for simulations using electron bunch lengths that are shorter than the SASE slice separation. The comparisons between the two codes for short bunch simulations elucidate the limitations of the SVEA in this regime but indicate that the SVEA can treat short bunches that are comparable to the cooperation length.
1 August 2021 in Journal of Physics Communications
Free-electron lasers (FELs) can emit light with different optical polarizations including linear, elliptic and circular polarizations corresponding to the characteristics of the undulators used. X-ray FELs depend upon long undulator lines consisting of a sequence of short undulators. Linearly polarized undulators are most commonly used; hence the optical output is linearly polarized. Alternately, APPLE-II, Delta undulator designs, or a sequence of linearly polarized undulators with alternating orientations can be used to produce undulating magnetic fields with arbitrary polarizations. We present a three-dimensional, time-dependent formulation that self-consistently includes two optical orientations and, therefore, treats any given sequence or combination of undulator including undulator imperfections and degradation There are two principal characteristics of the formulation that underpin this capability. First, particles are tracked using the full Newton–Lorentz force equations with analytic models of the undulators fields. This permits an accurate model of the interaction of the electrons with a large variety of undulator fields and orientations. Second, the electrons can couple simultaneously to two independent electromagnetic polarizations and, therefore, the optical polarization evolves self-consistently along the undulator line. We present the numerical model and give some examples using prevailing undulator configurations.
7 October 2020 in IEEE Transactions on Plasma Science
In this article, we discuss the use of a third harmonic component to the drive voltage on the grid of an inductive output tube (IOT). High-efficiency IOTs are typically characterized by efficiencies up to 70%-75%. However, the achievement of efficiencies greater than 80% would substantially reduce the operating costs of next-generation accelerators. In order to achieve this goal, we consider the addition of a third harmonic component to the drive signal on the grid of an IOT. The use of a third harmonic drive component in IOT guns has been considered in order to apply such a gun as the injector of radio frequency linear accelerators (RF linacs). Here, we consider that the IOT will be used to provide the rf power to drive RF linacs and apply the third harmonic with the intention of increasing the efficiency of the RF output of the IOT. We consider a model IOT with a 700-MHz resonant cavity and using an annular beam with a voltage of 30 kV, an average current of 6.67 A yielding a perveance of about 1.3 μP. We simulate this IOT using the NEMESIS simulation code which has been successfully validated by comparison with the K5H90W-2 IOT developed by Communications and Power Industries. It is found that the effect of the third harmonic on the efficiency is greatest when the phase of the third harmonic is shifted by π radians with respect to the fundamental drive signal and with third harmonic powers greater than about 50% that of the fundamental drive power. For the present example, we show that efficiencies approaching 86% are possible by this means.
Free-electron lasers (FELs) have been designed to operate over virtually the entire electromagnetic spectrum, from microwaves through to X-rays, and in a variety of configurations, including amplifiers and oscillators. Oscillators can operate in both the low and high gain regime and are typically used to improve the spatial and temporal coherence of the light generated. We will discuss various FEL oscillators, ranging from systems with high-quality resonators combined with low-gain undulators, to systems with a low-quality resonator combined with a high-gain undulator line. The FEL gain code MINERVA and wavefront propagation code OPC are used to model the FEL interaction within the undulator and the propagation in the remainder of the oscillator, respectively. We will not only include experimental data for the various systems for comparison when available, but also present, for selected cases, how the two codes can be used to study the effect of mirror aberrations and thermal mirror deformation on FEL performance.
19 March 2024 in IEEE Transactions on Plasma Science
We discuss the design and whole-cavity simulation of a multibeam inductive output tube (MBIOT) that uses a third harmonic component to the drive voltage on the grid. High-efficiency IOTs are characterized by efficiencies of 70%–75%. However, efficiencies greater than 80% would substantially reduce the operating costs of next-generation accelerators. To achieve this, we consider the addition of a third harmonic component to the drive signal on the grid. We consider an eight-beam MBIOT with a 700 MHz resonant cavity using a voltage of 35 kV and an average current of 7.25 A yielding a perveance of about 1.1 $\mu $ P. We simulate this using the NEMESIS simulation code which has been extended using a 3-D Poisson solver based on the Petsc package from Argonne National Laboratory. The effect of the third harmonic is greatest when the third harmonic phase is shifted by $\pi $ radians with respect to the fundamental drive and with third harmonic powers greater than about 50% that of the fundamental. We show that efficiencies approaching 82% are possible. Designs for the MBIOT input coupler, grids, and output cavity have been developed based on these simulations and will be discussed.
1 April 1995 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment