This paper presents experimental assessment of the effect of the ratio of vertical to horizontal peak ground acceleration (RVH) on underground metro station. An atrium-style metro station embedded in artificial soil subjected to earthquake loading is examined through shaking table tests. The experimental results for three different RVH, including soil acceleration, soil-structure acceleration difference, dynamic soil normal stress (DSNS), and structural dynamic strain, are presented and the results are compared with the case of horizontal-only excitation. It is found that for an atrium-style metro station, the differences in horizontal acceleration amplitude between the structure and the adjacent soil rise with increasing RVH, which are different at different depths. The most significant differences occur at the depth of the ceiling slab. It is also observed that both the amplitude and distribution of peak DSNS have obvious differences between the left and right side walls at all levels. It is therefore concluded that the RVH has a significant influence on dynamic soil-structure interaction. It is believed that under extreme earthquake loading, such as near fault zones, RVH is a parameter of paramount importance and should be accounted for in the seismic analyses and seismic performance assessments of underground structures, especially for those with zero or near-zero buried depth, such as atrium-style metro stations.

In the construction of mountain highway, in order to avoid complicated geology and adapt to the requirements of the terrain of the large height difference and the large slope, the double‐line spiral tunnels are gradually applied. The purpose of this paper is to analyze the mechanical behavior of the double‐line spiral tunnel and its surrounding rock under different line curvatures, and to obtain the influence of the curvature of the spiral tunnel on the stability of the double‐line tunnel construction. The analysis of this paper is based on the engineering background of double‐line spiral tunnels in China’s Yunnan province. The elastoplastic three‐dimensional rock strata‐tunnel by means of finite difference FLAC3D software was established to simulate the construction process. The model was verified by comparing the calculation results and the actual monitoring data of tunnel vault settlement. The small curvature radius spiral makes the mechanical behavior of the double‐line tunnel uneven and the surrounding rock deformed unevenly. A quantitative analysis and qualitative evaluation of the influence of curvature radius were established by the systematic evaluation index of (1) ratio of compressive stress on both sides of the tunnel, (2) stress ratio of double‐line tunnel, (3) convergent deformation of the cross section of the tunnel, and (4) deformation of the surrounding rock on the top of the tunnel. The results show that the small curvature radius (less than 200 m) will make the inner pressure of the inner tunnel significantly greater than the external pressure stress, showing obvious asymmetry, and the inner tunnel vault tensile stress is greater than the outer tunnel. With the increase of the curvature radius (about more than 400 m), the ratio of the compressive stress on the inside and outside of the tunnel tends to be constant, and the bias condition is weakened and stabilized. Meanwhile, the smaller curvature radius makes the convergent deformation of the cross section of the tunnel appear asymmetrical, and the compression quantity inside the tunnel center line is larger. It provides a reference basis for the stability control of the construction of the double‐line spiral tunnels in the mountainous area.

Analysis of seismic behavior of composite frame structures CFST columns;composite frames;damage identification;macro-model;nonlinear analysis; There are great needs of simple but reliable mechanical nonlinear behavior analysis and performance evaluation method for frames constructed by steel and concrete composite beams or columns when the structures subjected extreme loads, such as earthquake loads. This paper describes an approach of simplified macro-modelling for composite frames consisting of steel-concrete composite beams and CFST columns, and presents the performance evaluation procedure based on the pushover nonlinear analysis results. A four-story two-bay composite frame underground is selected as a study case. The establishment of the macro-model of the composite frame is guided by the characterization of nonlinear behaviors of composite structural members. Pushover analysis is conducted to obtain the lateral force versus top displacement curve of the overall structure. The identification method of damage degree of composite frames has been proposed. The damage evolution and development of this composite frame in case study has been analyzed. The failure mode of this composite frame is estimated as that the bottom CFST columns damage substantially resulting in the failure of the bottom story. Finally, the seismic performance of the composite frame with high strength steel is analyzed and compared with the frame with ordinary strength steel, and the result shows that the employment of high strength steel in the steel tube of CFST columns and steel beam of composite beams benefits the lateral resistance and elasticity resuming performance of composite frames.

Tunnel excavation tends to be affected by karst cavities in karst areas. Some cavities that are at low risk of causing safety issues without treatment tend to be ignored in the design and construction of tunnels to reduce costs. It is necessary to gain a better understanding of the effect of such a cavity on the seepage around a tunnel, the deformation of the surrounding rock, and the stress of the tunnel lining. In this paper, a two-dimensional rock-tunnel hydromechanical model with a karst cave was established with FLAC3D finite difference software to simulate the tunnel excavation with the consideration of seepage. Numerical simulations were performed to analyze the deformation of the surrounding rock, the seepage field of the surrounding rock, and the stress of the tunnel lining, and the results were compared for scenarios when the karst cave is at different locations relative to the tunnel. These results can provide a reference for the design and construction of tunnel engineering in rock with karst caves.