We report two strategies toward the synthesis of 3-alkyl-4-fluorothiophenes containing straight (hexyl and octyl) and branched (2-ethylhexyl) alkyl groups. We demonstrate that treatment of the dibrominated monomer with 1 equiv of alkyl Grignard reagent leads to the formation of a single regioisomer as a result of the pronounced directing effect of the fluorine group. Polymerization of the resulting species affords highly regioregular poly(3-alkyl-4-fluoro)thiophenes. Comparison of their properties to those of the analogous non-fluorinated polymers shows that backbone fluorination leads to an increase in the polymer ionization potential without a significant change in optical band gap. Fluorination also results in an enhanced tendency to aggregate in solution, which is ascribed to a more co-planar backbone on the basis of Raman and DFT calculations. Average charge carrier mobilities in field-effect transistors are found to increase by up to a factor of 5 for the fluorinated polymers.
The photostability of diketopyrrolopyrrole (DPP)-based copolymers is examined by investigating the natures of the two dominant optical absorption transitions.
Ferroelectric materials exhibit a phase transition to a paraelectric state driven by temperature - called the Curie transition. In conventional ferroelectrics, the Curie transition is caused by a change in crystal symmetry, while the material itself remains a continuous three-dimensional solid crystal. However, ferroelectric polymers behave differently. Polymeric materials are typically of semi-crystalline nature, meaning that they are an intermixture of crystalline and amorphous regions. Here, we demonstrate that the semi-crystalline morphology of the ferroelectric copolymer of vinylidene fluoride and trifluoroethylene (P(VDF-TrFE)) strongly affects its Curie transition, as not only a change in crystal symmetry but also in morphology occurs. We demonstrate, by high-resolution nanomechanical measurements, that the semi-crystalline microstructure in the paraelectric state is formed by crystalline domains embedded into a softer amorphous phase. Using in situ X-ray diffraction measurements, we show that the local electromechanical response of the crystalline domains is counterbalanced by the amorphous phase, effectively masking its macroscopic effect. Our quantitative multi-scale characterisations unite the nano- and macroscopic material properties of the ferroelectric polymer P(VDF-TrFE) through its semi-crystalline nature.
15 August 2013 in ACS Applied Materials & Interfaces
Transient photovoltage and photocurrent responses of organic solar cells provide valuable information regarding device performance and charge-carrier dynamics. However, the techniques used for analyzing these data have only been shown to be valid in a limited set of circumstances. Here we make use of a quasi-three-dimensional model to simulate these measurements in order to quantitatively evaluate the validity of the parameters extracted. With the experimentalist in mind, we produce a set of criteria that can be easily tested and demonstrate a good degree of generality for different sample parameters. This approach allows us to explore the use of “large perturbation” conditions in order to increase the signal-to-noise ratio and speed of the measurement. We propose the introduction of an “effective fixed capacitance,” which is shown to significantly reduce the uncertainty associated with the deviation from the small-perturbation regime.