This paper presents the modeling, design, fabrication and testing of monolithic electrostatic curved-electrode zipping actuators fabricated by deep reactive ion etching (DRIE). In contrast to traditional curved-electrode zipping actuators, the design of the actuators presented here utilizes a compliant starting cantilever to significantly reduce the initial pull-in voltage by closing the gap (kerf) generated by DRIE. Thus, the actuators achieve high actuation force at a relatively low voltage. For example, two actuators each with dimensions of 4.5 mm*100 /spl mu/m*300 /spl mu/m are used to drive a bistable MEMS relay. Together, the two actuators provide up to 10 mN of force over their 80 /spl mu/m stroke at 140 V. Measurements of the force-displacement relation of these actuators confirm theoretical expectations based both on numerical and analytical methods. Finite element analysis is employed to predict the behavior of the complete bistable relay system. [1231].
A model for the axially blown cylindrical arc is derived. In contrast to earlier theories, the model is gauge invariant with respect to energy, which is crucial for investigating current interruption. We determine from our model the dependence of the maximum interruptible current rate, , on the pressure, on the parallel capacitance, and on the line impedance for an arc. scales, approximately independent of the gas type, with the square root of the pressure. The arc resistance, at current zero with current rate equal to , is pressure independent. As a consequence, the arc resistance at current zero can serve as a figure of merit for the interruption performance of gas circuit breakers.
31 May 2009 in Journal of Quantitative Spectroscopy and Radiative Transfer
This paper reports on a strongly physics-based minimal circuit model for polycrystalline cores, such as ferrites, including dimensional resonance (DR). The models and main properties of DR and hysteresis are recalled, a circuit model is described that incorporates the various phenomena, and it is mentioned how its parameters are extracted by broadband linear response and low-frequency nonlinear measurements. Finally, the simulations are validated with measurements for a specific example. The model turns out to predict accurately the magnetic behavior in the high-frequency nonlinear region.