Calcium Alginate/Spent-Coffee-Grounds composite beads (CA-SCGs beads), which were made of two different proportions of alginate and spent-coffee-grounds (3:3 and 3:10), respectively, were used to adsorb Cu2+ in aqueous solution. These beads were compared with calcium alginate beads (CA beads) and spent-coffee-grounds (SCGs) in terms of adsorption capacity and rate of adsorption. The experiments were carried out at an initial pH of 4 at 30 °C with initial concentrations of Cu2+ from 10 ppm to 100 ppm. Equilibrium data was fitted with Langmuir, Freundlich and Sips models, and a pseudo-second-order kinetic equation. The Sips model showed the best correlation with the experimental values. CA-SCGs (3:3) beads showed a faster adsorption rate versus the CA beads. Also, CA-SCGs (3:3) beads showed a larger capacity of adsorption according to the Sips model, but not in the Langmuir model. FT-IR spectra and SEM images were taken for characterization. This study has shown that the CA-SCGs (3:3) beads have a synergistic effect, combining the capacity of adsorption of CA beads with the kinetics of the SCGs. The CA-SCGs beads have proven to be an effective adsorbent of Cu2+. Therefore, they can provide a use for the SCGs; which are considered pollutants in landfills.
27 February 2013 in Journal of Materials Chemistry A
Quantum dots of Cd(Se,S) and fluorescent magnetic nanocomposites (Cd(Se,S)–magnetite) were used as photocatalytic agents in the photodegradation of methylene blue (MB) under UV irradiation at pH 6.5. Quantum dots and magnetic nanocomposites were characterized by X-ray diffraction (XRD), UV-Vis, photoluminescence and Fourier Transform Infrared (FT-IR) spectroscopy. The photo-induced degradation of MB was monitored using High Performance Liquid Chromatography (HPLC) at 660 nm and titanium dioxide (anatase and aeroxide P25 forms) was used as the photocatalyst standard. A degradation of 99.1% and 90.0% of MB was achieved in the presence of 160 mg L−1-quantum dots and the magnetic nanocomposite, respectively, after 4.5 hours of UV-irradiation. Instead, 45.9% and 100% of MB degradation was achieved using 160 mg L−1 of TiO2 anatase and aeroxide P25, respectively. The degradation products were studied by mass spectrometry (MS) and the results evidenced the formation of azure B, A, C and phenothiazine. The reuse of the magnetic nanocomposites (i.e., after one photo-degradation cycle) allowed a maximum photo-degradation capacity of 65%. The results suggested that the nanocomposite has 10% less photodegradation capacity than the widely used catalytic agents such as TiO2 aeroxide P25.
13 January 2018 in International Journal of Environmental Research
Tire crumb rubber (TCR) was used to remove poly-aromatic hydrocarbons (acenaphthene and phenanthrene) and gasoline components in aqueous phase and toluene in gaseous phase. The initial concentrations were below the solubility of each contaminant. To better understand the role of the main components of TCR, the removal was also evaluated using carbon black (CB) and styrene-butadiene polymer (SBP). The Scatchard plots suggested multiple interactions between adsorbates and TCR, whereas a single interaction became evident for CB and SBP. The removal of gasoline components, and toluene and o-xylene in gasoline was evaluated using total ion current mode and selective ion monitoring mode, respectively. A gas chromatographer was modified to evaluate the removal of gaseous toluene. Toluene was injected at a rate of 30 μL/h. The isotherm was elaborated using pressures between 2.5 and 40 psi. The maximum uptake capacities (Kf) for TCR calculated from Freundlich’s equation for acenaphthene and phenanthrene were 3.32 and 54.6 mg/g, respectively; for total gasoline, toluene and xylene in gasoline were 4.0, 0.55 and 1.87 mg/g, respectively; and for gaseous toluene was 0.54 ± 0.04 mg/g. Its proven sorption capacity and low cost make TCR a promising sorbent for organic contaminants in aqueous and gaseous phases.
Quantum Dots (QDs) for bio-imaging applications need to be water-stable, exhibit high brightness and physico-chemical stability in order to prevent the leakage of toxic ions. In the present work, the direct synthesis of water-soluble CdSe quantum dots and their surface functionalization were achieved through a micro-wave assisted approach in aqueous phase. Glutathione, an essential tri-peptide, was used to functionalize the QDs as an attempt to develop a non-toxic and biocompatible surface. X-ray diffraction analyses suggested that as-synthesized QDs exhibited an alloy arrangement with an average crystallite size of 3.2 nm. HRTEM measurements suggested a size of around 4 nm for glutathione-functionalized QDs. Stable aqueous suspensions of QDs showed strong visible emission (551nm and 561 nm for bare and glutathione-functionalized QDs) under 460nm excitation. The presence of glutathione in the QDs’s surface was confirmed by FT-IR and NRM spectroscopy measurements. Surface characterization of QDs by using FT-IR indicated that glutathione was chemisorbed onto the surface of the CdSe QDs as carboxylate (vas COO at 1630 cm-1 and vs COO at 1390 cm-1). These water-stable glutathione- functionalized QDs can be considered a very promising nanomaterial for bio-labeling and imaging.
Size-exclusion chromatography (SEC) associated with High Performance Liquid Chromatography (HPLC) is a powerful tool to separate, purify and fractionalize materials based on size. In this paper, we present a SEC method that was developed for the separation of thiol-capped Cd(Se,S) quantum dots (QDs) synthesized in the aqueous phase. A HPLC system with a SEC column and a cascade of three detectors (UV/Vis, FLD and ELSD) was used to analyze the different size fractions of QDs. Nanocrystals–HPLC column interactions were suppressed using thioglycolic acid (TGA) as an ion pair agent. Five fractions, namely F1 to F5, of different sizes and tunable optical properties were isolated from the original QDs sample. The emission peaks for fractions F1 and F2 were red-shifted and the fractions F4 and F5 were blue-shifted compared with the original sample, which suggested the presence of nanocrystals having different sizes. Dynamic Light Scattering (DLS) confirmed that collected fractions exhibited different hydrodynamic diameters ranging from 98.2 nm (fraction F1) to 24.9 nm (fraction F5). Also, fractions F2 and F4 were functionalized with glutathione and analyzed by HPLC-SEC. Glutathione-capped Cd(Se,S) QDs showed an increase in their molecular weight, when compared to bare TGA-capped Cd(Se,S) QDs, without a remarkable change of their crystal size and optical properties. The developed SEC technique allows a fast and reproducible separation of water-stable Cd(Se,S) QDs. Collected fractions with tunable optical properties could have potential applications in the nanotechnology area such as bio-imaging and diagnostics, e.g. cell sorting.