There is a growing interest in the conversion of water and solar energy into clean and renewable H₂ fuels using earth-abundant materials due to the depletion of fossil fuel and its serious environmental impact. This critical review highlights some key factors influencing the efficiency of heterogeneous semiconductors for solar water splitting (i.e. improved charge separation and transfer, promoted optical absorption, optimized band gap position, lowered cost and toxicity, and enhanced stability and water splitting kinetics). Moreover, different engineering strategies, such as band structure engineering, micro/nano engineering, bionic engineering, co-catalyst engineering, surface/interface engineering of heterogeneous semiconductors are summarized and discussed thoroughly. The synergistic effects of the different engineering strategies, especially for the combination of co-catalyst loading and other strategies seem to be more promising for the development of highly efficient photocatalysts. A thorough understanding of electron and hole transfer thermodynamics and kinetics at the fundamental level is also important for elucidating the key efficiency-limiting step and designing highly efficient solar-to-fuel conversion systems. In this review, we provide not only a summary of the recent progress in the different engineering strategies of heterogeneous semiconductors for solar water splitting, but also some potential opportunities for designing and optimizing solar cells, photocatalysts for the reduction of CO₂ and pollutant degradation, and electrocatalysts for water splitting.

Formaldehyde (HCHO) is a major indoor pollutant and long-term exposure to HCHO may cause health problems such as nasal tumors and skin irritation. Photocatalytic oxidation is considered as the most promising strategy for the decomposition of HCHO. Herein, for the first time, a direct g-C₃N₄–TiO₂ Z-scheme photocatalyst without an electron mediator was prepared by a facile calcination route utilizing affordable P25 and urea as the feedstocks. Photocatalytic activities of the as-prepared samples were evaluated by the photocatalytic oxidation decomposition of HCHO in air. It was shown that the photocatalytic activity of the prepared Z-scheme photocatalysts was highly dependent on the g-C₃N₄ content. At the optimal g-C₃N₄ content (sample U100 in this study), the apparent reaction rate constant was 7.36 × 10⁻² min⁻¹ for HCHO decomposition, which exceeded that of pure P25 (3.53 × 10⁻² min⁻¹) by a factor of 2.1. The enhanced photocatalytic activity could be ascribed to the formation of a g-C₃N₄–TiO₂ Z-scheme photocatalyst, which results in the efficient space separation of photo-induced charge carriers. Considering the ease of the preparation method, this work will provide new insights into the design of high-performance Z-scheme photocatalysts for indoor air purification.